Q-See QSDB8209C User Manual - page 13

Manual is about: Digital LCD Baby Monitor and Wireless Camera

Summary of QSDB8209C

  • Page 1

    Qsdb8209c digital lcd baby monitor and wireless camera visit us on the web at http://www.Q-see.Com rev 072208.

  • Page 2

    Contents contents contents contents 1 packing list 2 diagram 3 structure 4 installation 5 specifications 6 fcc and eu 1. Packing list 1) 2.4ghz wireless camera ╳ 1 2) 2.4ghz wireless receiver ╳ 1 3) earphone ╳ 1 4) power adapter for camera ╳ 1 5) power adapter for receiver ╳ 1 note: aa batteries are...

  • Page 3

    2. Diagram 3. Structure 3-1. Layout of camera.

  • Page 4

    3-2. Layout of receiver 4. Installation 4-1. Setting up the camera 1. Setup the camera in the desired location.

  • Page 5

    2. Connect the camera to the adapter and then slide the power switch to the on position note: --this camera can also use dry batteries as a power source by loading 4 aa batteries into the battery compartment on the back of the camera with their polarities in the correct position. --the ac adapter wi...

  • Page 6

    4-1-1. Camera learning setup if there is interference from another wireless device the learning switch can program the unit to avoid it. Push the learning switch on the back of the camera from off to on, then press the eliminate button on the receiver for 3 seconds. The picture will become clearer o...

  • Page 7

    Sound alarm setup: to set up the sound alarm slide the alarm switch to the vox position. The system will enter standby mode until a sound triggers the alarm. When sound is detected the alarm sounds for two minutes or until the eliminate alarm button is pressed, which will put the system into snooze ...

  • Page 8

    Note: --this receiver can also use dry batteries as a power source by loading 4 aa batteries into the battery compartment at the back of the camera with their polarities in the correct position. --the ac adapter will work instead of batteries after it is plugged in. If the camera is not going to be ...

  • Page 9

    3. Set the channel of the receiver to the same channel as the camera by pressing the channel button continuously, the pictures will display on the screen when the channels match. Note: the receiver supports up to 4 cameras working at the same time. If there are 2, 3, or 4 cameras working you can pre...

  • Page 10

    5. Specifications item value general transmission frequency ism 2,400~2,483 mhz transmission power 10mw/ce; 2mw/fcc operating frequency 2414mhz;2432mhz;2450mhz;2468mhz unobstructed effective range 100m (328ft)(min.) spread spectrum/modulation mode fhss/gfsk operating temperature -10 ~ +50(degree c) ...

  • Page 11

    * actual transmission range may vary according to weather, location, interference and building construction. * all the specifications are subject to minor change without prior notice. 6. Fcc information this device complies with part 15 of the fcc rules. Operation is subject to the following two con...

  • Page 12

    Eu environmental protection electrical waste products (discharged batteries) should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice. Trademarks all brand names and products are registered trademarks of t...

  • Page 13

    Digital peripheral solutions inc. 8015 e crystal drive. Anaheim, ca 92807 1-877-998-3440. Q-see tech support in u.S.A. Mon-fri: 9 am 5 pm pst. Tel:1-877-998-3440 x 539 e-mail: ts@dpsi-usa.Com website: www.Q-see.Com.