Q4 Audio DPI 10 User Manual - page 4

Manual is about: Power amplifiers

Page of 15

Download

Print this page

Bookmark us

DPI SERIES USER MANUAL

Explanation of grahical symbols:

This symbol is intended to alert the user of pres-

ence of uninsulated dangerous voltage within

the products enclosure that may be of sufficient

magnitude to constitute risk of electric shock to

persons.

This symbol is intended to alert the user on the

presence of important operating and mainte-

nance (servicing) instructions in the literature

accompanying the appliance.

Explication des symboles graphiques:

Ce symbole doit alerter l’utilisateur du danger

provenant d’un voltage dangereux et non

protégé à l’intérieur de l’appareil, voltage suf-

fisamment fort pour représenter un danger réel

d’électrocution.

Ce symbole doit attirer l’attention de l’utilisateur

sur les instructions importantes qui concernent le

service et la maintenance et qui accompagnent

tout appareil.

Erklärung der Bildsymbole:

Dieses Symbol warnt den Benutzer vor nicht

isolierter gefährlicher Spannung im Inneren

des Gerätes. Diese Spannung ist hoch genug

um Personen durch elektrischen Schlag zu

gefährden.

Dieses Symbol weist den Benutzer auf wichtige

Bedienungs- und Wartungsanweisungen hin die

in den gerätebegleitenden Unterlagen aufgeführt

werden.

Note:

This equipment has been tested and found to comply with EN55103-1and EN55103-2 product specifications. These product

specifications are designed to provide a reasonable protection against harmful interference. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with instructions, can cause harmful interference. There is

no guarantee that interference will not occur in a specific installation. If harmful interference is detected try and correct it by one of the

following measures:

•

Increase the separation between the equipment.

•

Connect the equipment to different mains outlets.

•

Reroute cables.

1. Safety Symbols

CAUTION:

To reduce the risk of electric shoc, do not open.

No user-serviceable parts inside. Refer servicing to qualified

personnel.

WARNING:

To prevent fire or electric shoc, do not expose this

equipment to rain or moisture.

ATTENTION:

Pour éviter les risques de choc électrique, ne

pas ouvrir. Cet appareil ne comporte aucune pièce pouvant

être réparée par l’utilisateur. Confier l’entretien à un technicien

qualifié.

AVERTISSEMENT:

Pour éviter les risques de choc électrique

ou d’incendie, n’exposez cet appareil ni à l’humidité ni à l’eau

(pluie...).

ACHTUNG:

Um Gefährdung durch elektrischen Schlag zu

vermeiden darf das Gerät nicht geöffnet werden. Es befinden

sich keine vom Benutzer reparierbaren Teile im inneren des

Gerätes.Jegliche Reparatur soll einem qualifizierten Fachmann

uberlassen werden.

WARNUNG:

Um die Gefahr eines Feuers bzw. eine Verletzung

durch elektrischen Schlag zu vermeiden sollte das Gerät niemals

Regen oder Feuchtigkeit ausgesetzt werden.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

ATTENTION

RISQUE DE CHOC ELECTRIQUE

NE PAS OUVRIR

ACHTUNG

GEFAR FUR ELEKTRISCHEN

SCHLAG

GERÄT NICHT ÖFFNEN

« ‹ Prev 1 2 3 4 5 6 7 Next › »

Summary of DPI 10

Page 1
Dpi series user manual prelimenary professional power amplifiers r dpi 10 2 x 300 w dpi 15 2 x 500 w dpi 20 2 x 800 w dpi 30 2 x 1.100 w dpi 40 2 x 1.500 w.
Page 2
Dpi series user manual introduction thank you for choosing the q4audio dpi series for your ap- plication. You have made an excellent choice. Dpi series is part of a new breed of power amplifiers using our proprietary switching output stage, also called class d (cld) topology. The rugged steel chassi...
Page 3
Dpi series user manual 2 table of contents introduction ............................................................................................................................................................................................... . Safety symbols.......................................
Page 4
Dpi series user manual 3 explanation of grahical symbols: this symbol is intended to alert the user of pres- ence of uninsulated dangerous voltage within the products enclosure that may be of sufficient magnitude to constitute risk of electric shock to persons. This symbol is intended to alert the u...
Page 5
Dpi series user manual 4 2. Safety instructions all safety and operation instructions must be read before this unit is operated. The safety and operating instructions must be retained with the unit for future reference. All warnings on the appliance and in this operation manual must be strictly foll...
Page 6
Dpi series user manual 5 4.1 unpacking the unit 4. Setting up the amplifier dpi amplifiers are packed in a strong cardboard box that pro - tects it during transport. In case you ever need to ship the ampli- fier again it is best to pack it using the original packaging materials. Therefore it is advi...
Page 7
Dpi series user manual 6 5. Connecting the amplifier 5.1 familiarisation with the rear panel channel output is available on parallel wired neutrik 4 pole speakon and phoenix screw terminal. Wiring of the speakon is as follows: + = channel output positive - = channel output negative (ground) 2+ = cha...
Page 8
Dpi series user manual 7 the dpi series amplifiers have an open input architecture for future expansion. Standard, the amplifier is equipped with the pim-sim module. 5.3.2 pim-sim1 module . Channel input sockets are mixed xlr/phone jack recepta- cles, which allow the use of microphone or instrument ...
Page 9
Dpi series user manual 8 out + out sense + out + out sense + 5.3.4 mains connection for mains connection, use only three-prong mains connectors with earth contact. Switching the amplifier to different voltage systems is done from the inside and should only be performed by a qualified technician. The...
Page 10
Dpi series user manual 9 each channel is controlled from the front panel by a level con- trol potentiometer and 4 status led’s. The status led’s indicate the following operational states of the amplifier: ready/protect: two-coloured led indicates whether or not the channel is ready to operate. Light...
Page 11
Dpi series user manual 0 for maximum performance we recommend the use of two conductor shielded cable for making input connections. Because the shield does not carry audio signal, interference between signal current and audio current is minimised in this way. While wiring up your system take followi...
Page 12
Dpi series user manual model dpi10 dpi15 dpi20 dpi30 dpi40 min. Output power per channel into 2 ohms 500 w 900 w 200 w 600 w 2200 w 1 khz sine wave, thd min. Output power per channel into 4 ohms 300 w 500 w 800 w 00 w 500 w 1 khz sine wave, thd min. Output power per channel into 8 ohms 200 w 330 w 4...
Page 13
Dpi series user manual 2 9. Dimensions ready / protect signal bridge volt clip / limit ch 2 -db ch 1 -db temp limit supply ovl 0 oo 2 4 6 8 10 12 14 18 24 0 oo 2 4 6 8 10 12 14 18 24 professional power amplifier power on out + out sense + ch1 out + out sense configuration + ch2 w ar ni ng :r is k of...
Page 14
Dpi series user manual 3 10. Warranty summary the q4audio division of summit engineering nv tongersesteenweg 90 3800 sint-truiden belgium, the creators and manufacturers of the q4audio product line warrants to you, the original purchaser and any subsequent owner of this q4audio product, for a period...
Page 15: Service Request Form
Dpi series user manual 4 service request form send this service request form together with the unit (do not send separately!) to your authorised q4audio dealer, or to following address: summit engineering nv q4audio division tongersesteenweg 90 3800 sint-truiden belgium tel: +32 (0) 69 42 59 fax: +3...