Qleeno QS101 Operating Instructions Manual

Summary of QS101

  • Page 1

    Qleeno rev 102011 operating instructions read this manual and follow all the safety rules and operating instructions before using the product. This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid poss...

  • Page 2: Warning

    2 ! Danger ! Caution ! Warning notice signal words indicates situation which, if not avoided, will result in death or serious injury indicates situation which, if not avoided, could result in death or serious injury indicates situation which, if not avoided, could result in minor or moderate injury ...

  • Page 3: Warning

    3 ! Warning • if using detergents with qleeno, follow all instructions from the manufacturer. Use only non-foaming detergents. • as much as practical, operate qleeno on a surface clear of obstructions and other people. Use in well-lit areas. • qleeno is only suitable for use on flat surfaces, and is...

  • Page 4

    4 safety and general information save these instructions. For your safety, read, understand, and follow the information provided with and on this product before using. The owner and operator of this equipment shall have an understanding it's safe operating procedures before attempting to use. The ow...

  • Page 5

    5 preparation warning: always turn qleeno completely off and disconnect from power source when making adjustments, changing brushes, performing any type of cleaning, maintenance, or repair work. Caution: never use qleeno without an extension cord, brush or pad holder with pad. Use only accesso- ries...

  • Page 6

    6 mounting the brush/scouring pad 1. With kick stand folded up, lift qleeno to upright (vertical) position and turn brush/scouring pad holder counter- clockwise to remove it. 2. Mount brush and turn clockwise until it contacts mounting tabs on hub (ref. Photo below). 3. If using scouring pad, fasten...

  • Page 7

    2. Knob will lock into one of four detents in side of machine. Operation starting qleeno 1. Qleeno requires the use of an extension cord. Handle should be upright and locked. 2. Mount brush or pad holder with scouring pad according to the instructions on previous page. 3. Connect to common household...

  • Page 8

    After each use 1. Clean the hub insert and inside of the hub. 2. Empty water tank. Position qleeno over a floor drain and hold decrease water flow button down for 3 sec- onds to empty clean water. 3. Clean brush/pad and squeegee ring. Transporting qleeno caution: do not attempt lifting the entire ma...

  • Page 9

    Cleaning the hub warning: always turn qleeno completely off and disconnect it from the power source when not in use or before storing, making adjustments, changing brushes, performing any type of cleaning, maintenance, or repair work. Notice: the hub should be cleaned after each use to ensure optimu...

  • Page 10

    Adjustment of suction hoses notice: proper adjustment of the suction hoses is essential to good operation. Check hose adjustment on a regular basis. 1. Pinch hose to allow insertion into squeegee ring. 2. End of suction hose should be approximately 1-3/16" from squeegee ring surface. Weekly maintena...

  • Page 11

    Item part no. Description qty 1 710-3-9920-107 hood assembly repair kit 1 2 710-4-8700-104 water tank assy (includes parts 3, 4) 1 3 710-3-9922-101 tank fill (large) cap repair kit 1 4 710-3-9921-109 tank drain (small) cap repair kit 1 5 710-6-8706-108 water tank gasket 1 6 710-3-9903-107 fuse repai...

  • Page 12

    Sfa companies, inc. 10939 n. Pomona ave., kansas city, mo 64153 816.891.6390 customerservices@shinnfuamerica.Com two year limited warranty qleeno ® , represented in the united states by sfa companies ("sfa") warrants to the original purchaser that this product is free from defects in material and wo...