QMS Magicolor 6100 Supplementary Manual

Other manuals for Magicolor 6100: Operation, Installation Manual

Manual is about: QMS Magicolor 6100 Print system Operation

Page of 2

Download

Bookmark us

Make a note of the value (-4 to +4) associated with that

block, or simply mark the pane through the cutout in the

card.

You will need this value in step 6.

Repeat steps b–d with the magenta, yellow, and black

calibration cards.

Access the printer’s Administration/Engine/Density/Cyan

menu.

Adjust the cyan color density according to the number

you recorded in step 4.

Press the Previous key to decrease the density setting or the

Next key to increase the setting.

Repeat steps 5 and 6 for the magenta, yellow, and black

color densities.

Save your changes.

Print a new calibration page (Administration/Special

Pages/Calibration Page menu).

10 Compare the new calibration page to the four calibration

cards again.

11 Make any additional adjustments necessary.

If none are necessary, you’re done and ready to print.

QMS and magicolor are registered trademarks of QMS, Inc. All other trademarks

are the property of their respective owners.

Page 1
D make a note of the value (-4 to +4) associated with that block, or simply mark the pane through the cutout in the card. You will need this value in step 6. E repeat steps b–d with the magenta, yellow, and black calibration cards. 5 access the printer’s administration/engine/density/cyan menu. 6 ad...
Page 2
These instructions four color calibration cards—one each for cyan, magenta, yellow, and black use the following procedure to check and adjust the color density. Caution: for best results when checking the printer’s color density, print the calibration page described in step 3 on high quality paper, ...