Summary of PRO7
Page 1
User guide pro 7 headset system.
Page 2
If your installation requires more than one base you will require cat5 cable, two or more rj45 plugs and crimping tool - and a lan + rj45 network cable tester. These installation instructions are aimed at a person with a reasonable level of technical competence and familiar with the safety precautio...
Page 3
The base station (base) is a license-free dect wireless transceiver using a 48v dc external power supply. The system can be expanded with multiple bases, up to a maximum of 20, in a closed communications network linked by cat5 cable. The typical range of the base is up to 50 meters internally and up...
Page 4: Base Station
If you plan to mount the base higher than 2m above floor level consider installing a registration button - it should be wall- mounted underneath the base so you can see the base leds during the registration process. The registration button is used to activate the registration process (press for five...
Page 5
Useful tip power to the bases should use a constant 24hr power outlet. If one or more mains circuits is switched off, it may affect the operation of the entire base network. Follow the type b wiring protocol for all rj45 plugs colour code as shown right. Rules when installing multiple bases on the s...
Page 6: Power Led
The two leds on the front of the base indicate its status, as below: pro 7 headset system power led status led booting up base is master and ready base is slave and ready synchronization signal receiving ok active call or calls on this base both leds flashing corrective action power too low to boot ...
Page 7
The headset charger should be positioned on a worktop and plugged into a socket that is a constant 24hr power outlet. The charger should be located within range of a base so that headsets remain active at all times. Return headsets to the charger when not in use. Charge time is approximately 2.5 hou...
Page 8
Each headset needs to be registered to the system for the first time before use. The system has the capacity for 30 headsets. To register one or more headsets, follow this procedure: 1 make sure the new headset has a charged battery (blue led flashes every five seconds). 2 make sure all the headsets...
Page 9: Status
Volume there are five volume settings. Use the toggle at the rear of the headset to adjust volume by pressing upwards for each step. Speech the headset can be used in two speech modes: - talklock this mode is hands-free. To activate, press the silver button for less than one second - the headset is ...
Page 10: Accessories
Pro 7 headset system product specifications base station q-p7bs operating frequency 1.88-1.90 ghz emea, asia, 1.910-1.930 ghz north america dect transmission power 250 mw emea, asia 125 mw north america headset capacity up to 30 headsets all listening with a max of 6 simultaneous participants multip...
Page 11
11 headset q-p7hs operating frequency 1.88-1.90 ghz emea, asia, 1.910-1.930 ghz north america operating modes talklock and ptt as standard microphone noise cancelling, electric mic battery capacity 6 hours talklock, 8 hours ptt charge time 2.5 hours volume control 5-stage, slide button up/down batte...
Page 12: Www.Quaildigital.Com
Www.Quaildigital.Com 18 .06 .14 ic id: 6402a-q-p7bs this device complies with industry canada licence-exempt rss standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference tha...