Quartech 2800 Manual - page 15
2800 & 2900 Series PLC Drivers
Page 15
DM2829_PLC Revision 2
Toshiba EX100
Quartech Part Number: 2159-0
Toshiba Port
2800/2900
8 Pin Male Connector
15 Pin Female D-Type
SC
A4 <
)))))))))))))))))))))))
< 11
SC
RXD
A3 <
)))))))))))))))))))))))
< 6
TXDA
TXD
B3 <
))))))))))))))))))))0))
< 13
RXDA
+)Y
4.7K
Z)-
+5
B4 <
)))))))))3)))))))))))))
< 15
+5
.)Y
4.7K
Z)0))
< 12
RXDB
+)Y
2.7K
Z)-
.)))))))))))))
< 10
SC
+)))))
< 4
RTS
.)))))
< 5
CTS
Drain Wire
))))
< 1
FG
Toshiba EX100
The Toshiba EX100 is a non standard interface intended for point to point communications, i.e., only a single
peripheral device may be connected to the port. This driver is compatible with Toshiba models EX100, EX250, EX500,
M20, and M40. It is also compatible with the Cutler-Hammer D500 processor.
ScreenMaker 2000 Port setup:
Command Word Address: Internal Relays (RW Type), one word
Screen Trigger Address: Data Register (D Type), two contiguous words
Interface type: Custom, 4800 bps, 8 data bits, 1 stop bit, even parity.
The following schematic shows the cable connections required between the OIT and the Toshiba programming port.
This cable is available from Quartech in a standard length of ten feet. Cables up to twenty five feet in length may be
ordered.