Quinnamp SDQ1b Owner's Manual - page 3
OVERDRIVE SECTION- controls set the basic gain and volume levels of the
Overdrive Channel.
OVERDRIVE- This control sets the amount of overdrive when using the OVERDRIVE channel.
Lower settings yield cleaner overdriven tones. Higher settings will overdrive more.
Keep in mind that the VOLUME control in the PREAMP SECTION also affects how much signal gain from
the CLEAN CHANNEL is being cascaded into the OVERDRIVE CHANNEL. If set too low you may not have
a pleasing OD sound. If set too higg your cleans might not be clean enough. Again the "sweet spot" is
generally noon to 2 O'clock.
VOLUME- This control sets adjusts the Volume of the OVERDRIVE CHANNEL.
Use this to balance the volume of the Overdrive Channel with the Clean Channel
With no footswitch plugged in you can pull this control to turn off the OVERDRIVE CHANNEL and
engage the CLEAN CHANNEL. With the footswitch plugged in set this control to appropriate level and
use footswitch to toggle between CLEAN & OVERDRIVE CHANNELS.
Master Section
:
3