Quinnamp SDQ1b Owner's Manual - page 9
4,5 and 6 functions "Artist" footswitching will be available in the future and are currently only
available by custom order. (Add $100 per additional function)
Included is a 25’ footswitch cable.
The cable used is a regular MIDI cable and is readily available in any length at most music
stores. If a replacement cable is needed, make sure all 5 wires are supported.
We recommend HOSA brand.
NOTE: The footswitch buttons will only function when associated panel switches are pushed in.
POWER ON/OFF PROCEDURE:
1. Check the Standby switch to make sure it is toggled downward for Standby operation.
2. Toggle the main power switch to the up position (this switch is located at the top of the IEC
input module). The front panel pilot light should be lit.
3. Wait one minute and then toggle the Standby switch upwards to the Operate position.
4. POWER OFF – Toggle the main power switch downward, there is no need to go into
standby first although it will not hurt anything.
MAINTENANCE SECTION:
Your SDO amp has been designed for years of trouble free operation. The vacuum tubes
will need to be replaced over time. We recommend new output tubes every 160 - 240 hours
and new preamp tubes every 320 - 480 hours.
Tube Chart:
9