Copyright 2017 dtx international all rights reserved 3 a b c d e f g a) trainer frame b) resistance unit c) resistance unit mounting bolt d) resistance unit lock nut and washer e) wrench set f) skewer g) riser block safety recommendations important! The hydromax trainer is rated for a maximum load o...
Copyright 2017 dtx international all rights reserved 4 assembly instructions attaching the resistance unit to the trainer 1) using the resistance unit mounting bolt (c), attach the resistance unit (b) to the trainer frame (a) through the bracket at the base of the frame. See figure 1 . 2) place the ...
3) adjust the knob on the resistance unit to ensure good contact with the rear wheel. Do not over- tighten. Over-tightening will cause both excessive tire wear and possible damage to the trainer. See figure 7. 4) place the riser block ( part g ) under the front wheel as shown below. Figure 6 figure ...
