RAD Cycle Products RAD MAX Prozone 1102 Instruction Manual - page 5
1) With a bicycle locked into the trainer, push
the blue locking lever down to push the mag
roller closest to the rear wheel. [Figure 1]
2) Begin adjusting the knob counter clockwise
[Figure 2] to increase friction, or clockwise
[Figure 3] to decrease friction until the mag
roller comes in contact with the rear wheel.
3) Push the
blue locking
lever back up to
bring the mag
roller away
from the tire. [Figure 4]
4) Turn the adjustment knob counterclockwise a
few turns and again push the blue locking lever
down so that the mag roller comes in contact with
the rear wheel.
5) Repeat step 4 until desired friction is achieved
and rear wheel does not slip when riding.
[NOTE] Too much friction between the mag roller and the rear tire will cause
excessive wear on your tire tread.
How to adjust the Prozone Trainer for Use
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
Copyright © 2012 DTX International
5