RAD Cycle Products RAD MAX Prozone 1102 Instruction Manual - Operating Instructions
For best results make sure that your tires are
inflated to the maximum pressure
allowed for your tire.
To avoid unnecessary wear and tear on your
bike tires, when not using your PROZONE
trainer, make sure the resistance is set to
not touch the tires.
To attach your bike to the trainer, first:
1.
Unfold your trainer and place on a
level, flat surface (Figure 2).
2. Release the quick release lever on
the back wheel of your bike and
replace it with the Tightening Rod
(Figure 3). Unscrew the end fitting of
the rod and slide the Tightening Rod
through your bike’s rear wheel.
FIGURE 2
6
Copyright 2012 DTX International
FIGURE 1
FIGURE 6
FIGURE 7
FIGURE 3
FIGURE 4
FIGURE 5
ATTACHING YOUR BIKE TO THE PROZONE TRAINER
OPERATING INSTRUCTIONS
End Fitting
Rake Quick
Clamp
Rake Quick
Clamp
FIGURE 8
3. Please use the spanner and allen key to fitting the Magnetic
Resistance Set.
4. When screw is in Position A, It suitable for 28" wheels (Figure7).
When In position B, It is suitable for 26" wheels (Figure8).
5. Once your bike is held securely, the rest is easy. Simply close
the Rake Quick Clamp by pressing down firmly but gently
(Figure 4), then tighten the securing nut on the opposite side to
tighten completely (Figure 5).