RAD Cycle Products RAD MAX Prozone 1102 Instruction Manual - Using Your Prozone Trainer
7
Copyright 2012 DTX International
6. Thread the cable for the handlebar resistance controls around
your bike and mount the resistance controller to your handle-
bars. Be sure to attach the controller within easy reach of your
hands while riding (Figure
9
).
7. Don’t forget to place the anti-slip leveling stand under the
front tire of your bike, and you’re ready to go! (Figure
10)
.
Your bike’s own gears in conjunction with the PROZONE Trainer’s
7 levels of resistance offers infinite configurations for a
completely customized workout.
Make sure that the controller cable is clear of the wheels and that
the hub connections are secure. Always check that the front wheel
is secure in the anti-slip stand before using the PROZONE Trainer.
It is important to properly warm up before doing any kind of exercise
and check to make sure your bike tires are inflated to the proper PSI.
ALWAYS keep both hands on your handlebars when riding.
1. Remove the resistance controller and cable from your
handlebars.
2. Open the Rake Quick Clamp on the top of the trainer by
pressing up firmly but gently (Figure 4), then loosen the
securing nut on the opposite side (Figure 5).
3. Unscrew the end fitting of the rod and slide the Tightening
Rod out of your bike’s rear wheel (Figure 3). Remove the
anti-slip leveling stand and your bike is now free from the trainer.
4. To store your trainer simply fold and store out of the way
until your next use (Figure 1
1
). Be careful to avoid pinching your
fingers when folding and avoid storing other equipment on top
of your trainer.
Take care to protect the magnetic resistance set, its adjustment knob
and the controller cable.
Customer service and product support are available online at
www.radcycleproducts.com.
ATTACHING YOUR BIKE TO THE PROZONE TRAINER
USING YOUR PROZONE TRAINER
OPERATING INSTRUCTIONS
REMOVING YOUR BIKE FROM THE TRAINER