Radeum FreeLinc Adapter Series User Manual
FCC Compliance
This equipment has been tested and found to comply with the limits for a
class B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radi-
ate radio frequency energy and, if not installed and used in accordance
with the manufacturer’s instructions, may cause interference harmful to
radio communications.
There is no guarantee however, that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by comparing
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult your supplier or an experienced radio/TV technician for
assistance.
Warning: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority to
operate this equipment.
Safety Information
Caution: To reduce the risk of fire or injury to persons, read and follow these instruc-
tions.
Do not dispose of headset in a fire. The cells may explode.
Check with local codes for possible battery disposal instructions.
Use only the supplied charging unit to charge the headset from an AC voltage or wall
outlet.
If the headset becomes hot during charging, disconnect the AC adapter from the wall
and contact qualified support personnel.
Do not disassemble the AC adapter of this product as it may expose you to danger-
ous voltages or other risks. Incorrect reassembly can cause electric shock when the
product is subsequently used.
Do not use the charger outdoors or in damp areas.
Only charge the headset battery in accordance with the instructions of this manual.
Never submerge your headset in water or other liquids.
Protect your headset from spills, excessive rain, and wet locations.
Do not use liquid cleaners or aerosol cleaners as they may damage the headset or fin-
ish of the headset. Use a dry cloth to clean the external portions of the headset.
Do not stick anything inside the product as this may damage internal components.
This product conforms to the following safety standards:
ANSI/UL 60950-1 1st Ed.
CAN/CSA C22.2 No. 60950-1-03
EN 60950-1 1st Ed.
SAFETY AND WARRANTY INFORMATION
Warranty
FCC Compliance
Safety Information
TABLE OF CONTENTS
INTRODUCTION AND GENERAL INFORMATION
CONTENTS IN PACKAGES
PARTS OF THE PRODUCT
Diagram/Terms
Indicator Lights
GENERAL OPERATION
Using Your Headset for the First Time
Step One: Attach Adapter
Step Two: Turn On Adapter
TIPS AND SUGGESTIONS
TROUBLESHOOTING
Table of Contents