Radio Shack 61-140 User Manual

Download

Print this page

Bookmark us

61-140

User’s Guide

Wireless

Two-Bell Door Chime

Thank you for purchasing your Two-Bell Door Chime from

RadioShack

. Please read this user’s guide before installing,

setting up, and using your new door chime.

Package Contents

• Wireless Door Chime

• Nylon lanyard

• Bell 1

• Bell 2

• Remote Mounting Bracket (2)

• M 3 Screw (4)

• Anchor (5)

• M 2.6 Brass Screw (2)

• M 3.5 Screw (5)

• User’s Guide

• Quick Start

Select Channels

Remove the battery compartment covers on the door

chime and the two bells.

Select the same channel (1, 2, or 3) in the door chime and

doorbell 1.

Repeat step 2 for the doorbell 2.

Notes:

• Remove batteries and follow above steps to change

or reset the channel on your door chime and remote

doorbells.

Mount Your Door Chime

You can mount your door chime on a door or wall, or set it on a

flat surface using the attached metal stand. To mount to a door

or wall:

Drill a ¼ inch hole in the door or wall and insert an anchor.

Screw an M 3.5 screw into the anchor, leaving the head

extended about

inch.

Align the door chime’s rear keyhole slot to the screw head

and slide the chime down to lock in place.

Mount Your Doorbell

Mark two holes using the mounting bracket as a guide. Drill

a ¼ inch hole at each mark. Insert an anchor in each hole.

Align your mounting bracket with the anchors and screw a

supplied M 3.5 screw into each anchor.

Slide your doorbell into the bracket. To lock the doorbell in

place, insert a supplied M 2.6 screw into the bottom of the

mounting bracket.

• If your door chime rings when no one presses one of the

remotes, you may be receiving interference. Switch the

affected door chime and doorbell to another channel.

Install Batteries

Insert three C batteries

in your door chime as

indicated by the polarity

symbols (+ and – ).

Insert three AAA batteries

in each remote doorbell as

indicated by the polarity symbols

(+ and – ).

Replace the covers.

Notes:

• Replace the door chime’s batteries

if it buzzes and the LED flashes red.

• Replace the doorbell’s batteries if

the LED turns off.

• Use only fresh batteries of the required size and type.

• Dispose of old batteries promptly and properly. Do not

burn or bury batteries.

• Do not mix old and new batteries, different types

of batteries (standard, alkaline, or rechargeable), or

rechargeable batteries of different capacities.

• If you do not plan to use the alarm for a month or longer,

remove the batteries. Batteries can leak chemicals that can

destroy electronic parts.

2/2

You can also use the supplied lanyard to carry your doorbell

with you as a panic alarm or to let someone know you have

arrived.

Slip the small end through the hole at the top of the

remote doorbell.

Thread the thick end through the loop at the thin end and

pull through.

Use Your Door Chime

Slide your door chime to

Press the button on one of your doorbells. Your

chime will “ding dong” for doorbell 1 and play

“Home Sweet Home” for doorbell 2.

Slide the door chime to

OFF

when you don’t

want to hear it ring.

and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

• Consult your local

RadioShack

store or an experienced radio/TV technician

for help.

If you cannot eliminate the interference, the FCC requires that you stop

using your equipment. Changes or modifications not expressly approved by

RadioShack

may cause interference and void the user’s authority to operate

the equipment.

This device complies with Part 15 of the FCC rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference,

and (2) This device must accept any interference received, including interfer-

ence that may cause undesired operation.

Limited Warranty

RadioShack

warrants this product against defects in materials and workman-

ship under normal use by the original purchaser for

ninety (90) days

after

the date of purchase from a

RadioShack

-owned store or an authorized

RadioShack

franchisee or dealer.

RADIOSHACK

MAKES NO OTHER

EXPRESS WARRANTIES.

This warranty does not cover: (a) damage or failure caused by or attribut-

able to abuse, misuse, failure to follow instructions, improper installation or

maintenance, alteration, accident, Acts of God (such as floods or lightning),

or excess voltage or current; (b) improper or incorrectly performed repairs

by persons who are not a

RadioShack

Authorized Service Facility; (c)

consumables such as fuses or batteries; (d) ordinary wear and tear or cosmetic

damage; (e) transportation, shipping or insurance costs; (f) costs of product

removal, installation, set-up service, adjustment or reinstallation; and (g) claims

by persons other than the original purchaser.

Should a problem occur that is covered by this warranty, take the product and

the

RadioShack

sales receipt as proof of purchase date to any

RadioShack

store in the U.S.

RadioShack

will, at its option, unless otherwise provided by

law: (a) repair the product without charge for parts and labor; (b) replace the

product with the same or a comparable product; or (c) refund the purchase

price. All replaced parts and products, and products on which a refund is

made, become the property of

RadioShack

. New or reconditioned parts and

products may be used in the performance of warranty service. Repaired or

replaced parts and products are warranted for the remainder of the original

warranty period. You will be charged for repair or replacement of the product

made after the expiration of the warranty period.

RADIOSHACK

EXPRESSLY DISCLAIMS ALL WARRANTIES AND CONDI-

TIONS NOT STATED IN THIS LIMITED WARRANTY. ANY IMPLIED WAR-

RANTIES THAT MAY BE IMPOSED BY LAW, INCLUDING THE IMPLIED

WARRANTY OF MERCHANTABILITY AND, IF APPLICABLE, THE IMPLIED

WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, SHALL EXPIRE ON

THE EXPIRATION OF THE STATED WARRANTY PERIOD.

EXCEPT AS DESCRIBED ABOVE,

RADIOSHACK

SHALL HAVE NO LIABILITY

OR RESPONSIBILITY TO THE PURCHASER OF THE PRODUCT OR ANY

OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR

DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE

OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WAR-

RANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING

FROM INCONVENIENCE AND ANY LOSS OF TIME, DATA, PROPERTY,

REVENUE, OR PROFIT AND ANY INDIRECT, SPECIAL, INCIDENTAL, OR

CONSEQUENTIAL DAMAGES, EVEN IF

RADIOSHACK

HAS BEEN ADVISED

OF THE POSSIBILITY OF SUCH DAMAGES.

Some states do not allow limitations on how long an implied warranty lasts

or the exclusion or limitation of incidental or consequential damages, so the

above limitations or exclusions may not apply to you. This warranty gives you

specific legal rights, and you may also have other rights which vary from state

to state. You may contact

RadioShack

at:

RadioShack

Customer Relations

300 RadioShack Circle, Fort Worth, TX 76102

04/08

www.RadioShack.com

Printed

in China

02B11

61-140

RadioShack

Corporation.

RadioShack

and

RadioShack.com

are trademarks used by

RadioShack

Corporation.

Protect the environment by recyling used electronics. Go to

E-CyclingCentral.com to find an electronic recycling center near you.

- OR -

ON/OFF.

Channel Switch

Must be set to

same channel

Bell 1

Bell 2

Door Chime

Channel Switch

Must be set to

same channel

- OR -

Add Another Alarm

You can expand your doorbells to sound an

additional alarm. To do this, you will need to wire

one or both doorbells to an alarm that contains a

normally open contact.

Connect both tips of a 2-conductor wire (not

supplied) to a doorbell, as shown, using two

M3 screws.

Connect both tips of the other end of the

2-conductor wire to the extra alarm.

Now, when you press your doorbell, both the door

chime and the alarm will sound.

Specifications

Frequency .............................................. 433.92 MHz ± 600 KHz

Doorbell current consumption .....................................

Chime current consumption ........................

........................................................................

Chime battery low ................................................. 2.4 V ± 0.1 V

Chime audio power .......................... > 80 dBA @ 10 in (25 cm)

Doorbell operating temperature.......................–4° F to 140° F

...........................................................................(–20° C to 60° C)

Specifications are subject to change and improvement without notice.

Actual product may vary from the images found in this document.

FCC Information

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off