Range Senator RFB006 6kW Installation And User Instructions Manual - page 3
DESCRIPTION
The Electric Flow Boiler is designed to heat re-circulated water in wet central heating systems. The water is heated when it is passed over electric
immersion elements, which are contained within a stainless steel chamber. The temperature of the water is monitored and controlled by a modulation
technique switching the immersion elements. The switching of the elements is carried out by solid-state technology under the
control of a microcomputer contained in the control section of the boiler.
The operation of the boiler can be controlled by standard room thermostatic controls, etc. The pump MUST be connected to the boiler control, which
provides the run-on facility.
FEATURES
Domestic hot water is available via an indirect cylinder.
Can be used in pressurized installations or open vented systems.
No flue or fuel tank required.
Quiet in operation.
Operates from standard room thermostatic controls, etc.
Pump run-on facility.
Solid-state technology enables zero volt switching.
Soft start and soft modulation.
Front panel operation indicators.
Automatic self check every time it operates.
Optical isolation to enable connection of multiple boilers on single or 3 phase supply.
Electrical tails termination’s inside the boiler.
Safety trip for no water or no flow or excessive element current.
Warning of element failure.
WARRANTY
Your Electric Flow Boiler warranty covers defects originating from faulty workmanship and materials used in the manufacture of the boiler, for a period
of 5 years on the stainless steel chamber and 2 years on all other components. In the event of a potential warranty claim always quote the boiler serial
number. No claims will be considered without this number. The warranty covers the replacement of any faulty parts and our labour costs to replace
the faulty parts. It does not cover the cost of removing, returning and refitting the boiler or any secondary losses arising from the failure.
Under no circumstance should the boiler be dismantled prior to return. Failure to comply with this instruction will invalidate the warranty.
Defects arising from incorrect installation, water contaminates, harmful chemicals, system impurities, calcium build up, faulty ancillary equipment,
mechanical or electrical abuse, lightning or any other circumstances beyond our control, are not covered by the warranty.
The boiler is designed to operate the majority of wet central heating systems in domestic, commercial, industrial and public buildings. It must not be
used in any environment that has been classified as hazardous and could therefore cause a fire or explosion, or where their is a danger of ignition by
a flame path.
The warranty will be invalid if the boiler has not been installed correctly according to these instructions, standard codes of practice, including all
safety controls or if the recommended inhibitor is not used.
The warranty will be invalid if water leaks into the boiler from any external source. Ensure all joints and connections are water tight, pay particular
attention to those above the boiler. Under no circumstances is the case to have additional holes drilled into it. In the event of a potential warranty
claim, always quote the boiler’s serial number. No claims will be considered without this number.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
3