?rate FlexWave 120H Owner's Manual - The Dsp Section

Manual is about: Three-channel guitar amplifier with DSP and channel tracking

Summary of FlexWave 120H

  • Page 1

    Three-channel guitar amplifier with dsp and channel tracking owner’s manual.

  • Page 2: Table of Contents

    Flexwave120h guitar amplifier w/dsp and channel tracking 2 important safety instructions • read, follow, heed, and keep all instructions and warnings. • do not operate near any heat source and do not block any ventilation openings on this apparatus. For proper operation, this unit requires 3” (75mm)...

  • Page 3: Introduction

    Flexwave120h guitar amplifier w/dsp and channel tracking introduction congratulations! You are now the proud owner of the crate flexwave120h three-channel guitar amplifier with advanced digital signal processing (dsp) and channel tracking. This rug- ged amplifier combines outstanding features with s...

  • Page 4: Channel Tracking

    Flexwave120h guitar amplifier w/dsp and channel tracking channel tracking your crate flexwave120h gives you the power of channel tracking. Once you select a dsp setting for each channel, channel tracking stores the settings to memory whenever you change channels. When you go back to that channel, ch...

  • Page 5: The Front Panel

    Flexwave120h guitar amplifier w/dsp and channel tracking 1. Power: use this switch to turn the amplifier on (top of the switch depressed) and off (bottom of the switch depressed). The switch illuminates when the amplifier is turned on. 2. Electronic tuner: the electronic tuner is active whenever the...

  • Page 6: The Rear Panel

    Flexwave120h guitar amplifier w/dsp and channel tracking 6 bank a bank b 4 ohm min load clean / od high gain 100 vac: 250v t4a 120 vac: 250v t3a 230/240 vac: 250v t1.6a ext spkr dsp insert channel footswitch 26 25 27 28 29 30 21. Shape: use this control to “dial in” the tone for the high gain channe...

  • Page 7: The Dsp Section

    Flexwave120h guitar amplifier w/dsp and channel tracking 7 the dsp section signal path mod + delay + reverb effect setting description chorus 1 chorus with low depth chorus 2 chorus with medium depth chorus 3 chorus with high depth flanger 1 flanger with low depth flanger 2 flanger with medium depth...

  • Page 8

    Flexwave120h guitar amplifier w/dsp and channel tracking 8 using the footswitch with the dsp the crate three-button footswitch supplied with the flexwave120h allows access to an addi- tional dsp preset for each channel of the amplifier. When the footswitch is connected to the amplifier as shown belo...

  • Page 9: Suggested Settings

    Flexwave120h guitar amplifier w/dsp and channel tracking suggested settings sweet ‘n clean: just a ‘lil nasty: politely gritty: down ‘n dirty: mean & obscene: 9 out as desired overdrive clean high gain overdrive delay cd mod reverb high mid low volume level high mid low gain level shape gain input e...

  • Page 10: System Block Diagram

    Flexwave120h guitar amplifier w/dsp and channel tracking system block diagram 10 input clean/ overdrive low volume mid high reverb buffer mix amp clean damping circuit power amp ext. Speaker overdrive/ high gain insert high gain gain overdrive level high gain level overdrive gain mid low high shape ...

  • Page 11

    Flexwave120h guitar amplifier w/dsp and channel tracking 11 this equipment has been tested and found to comply with the limits for a class b digital device, pur- suant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference in a residentia...

  • Page 12: Service Information:

    Flexwave120h guitar amplifier w/dsp and channel tracking flexwave120h technical specifications: output power rating 120w rms @ 5% thd into 4 ohm load, 120 vac gain high gain channel 110 db, all controls @ 10 overdrive ch 88 db, all controls @ 10 clean ch 58 db, all controls @ 10 cd input 29 db maxim...