S&B Lawn Systems Lawn Stryper LM–408111B Owner's Manual

Summary of Lawn Stryper LM–408111B

  • Page 1

    Visit www.Patternyourlawn.Com owner ’ s manual read, understand and follow all instructions prior to use. Lea, entienda y siga todas las instrucciones antes de usar. S&b lawn systems, inc. / w226n825 eastmound drive, suite b waukesha, wi 53186-1690 usa / visit www.Patternyourlawn.Com model no. Lm–40...

  • Page 2: •

    Congratulations... On your purchase of the lawn stryper tm , a s&b lawn systems, inc. Product. The lawn stryper tm attachment is designed to easily and safely attach to most walk-behind, self-propelled and push-type lawn mowers. When used properly, the lawn stryper tm attachment will allow you to pa...

  • Page 3

    Parts: a. (2) bsi-lns-011 lawn stryper tm inner clamp(s) b. (2) bsi-lns-012 lawn stryper tm outer clamp(s) c. (2) bsi-lns-015 lawn stryper tm angle adjuster(s) d. (1) bsi-lns-003 lawn stryper tm hitch tube e. (2) bsi-lns-017 lawn stryper tm corner tube(s) f. (2) bsi-lns-013 lawn stryper tm vertical ...

  • Page 4

    G pour dry sand into opening. H step 1 step 1: fill roller assembly with approximately 16 to 20 lbs. Of dry sand. Completely fill roller tube (g), with sand, via hole located on end of tube. Once completely filled, thread and fully tighten roller plug with provided roller plug fastener. User tip! Fa...

  • Page 5

    F c i step 3 step 3: insert vertical tubes into angle adjusters. Set vertical tube (f) into angle adjuster (c). Make certain that top portion of vertical tube (f) rests flat on inner portion of angle adjuster (c) as outlined in above diagram. Screw holes should match up. Insert 2" pan head screw (i)...

  • Page 6

    Lawn mower handlebars f f e e d valco holes valco holes valco pins valco pins step 5 step 5: attach hitch tube and corner tubes to vertical mount system. Attach hitch tube (d) to corner tubes (e) by pressing down on valco pins and locking into place as outlined in diagram above. Set width of u-bar a...

  • Page 7

    G d step 7 step 7: - attach roller assembly to hitch tube. Attach sand filled roller assembly (g) onto hitch tube (d) by vertically sliding onto hitch as outlined in above diagram. User tip! When you don’t want the patterning effect, or perimeter cut is necessary, or when there are obstructions such...

  • Page 8

    General tips: visual results may vary based upon health of grass, length of grass, available sunlight and seasonal conditions. A less dramatic patterning effect can be a result of insufficient sunlight, dormant grass, unhealthy grass, or when used on warm-season grass such as bermuda and st. Augusti...

  • Page 9

    Troubleshooting: roller does not turn: • with mower turned off, check to see if any type of debris such as bark, twigs, stones, or other objects have obstructed the roller’s ability to turn. If so, with mower turned off, remove debris from the roller. • make certain that roller plug, on roller tube,...

  • Page 10

    Lawn care tips continued: watering your lawn: when your lawn begins to look stressed or when you step on and it does not bounce back, it may be time for a thorough watering. Approximately 1 to 2 inches of water, equally distributed, should do the job. Watering should occur during the early morning h...