S4 Tech DOG User Manual - page 20
S4 Tech Inc
19
•
Use the up/down arrows and the
ENTER
key to create a detection area profile on the screen.
Anything outside the defined area will not be detected.
•
Press
ESC
to go up one menu layer
•
Select
SENSITIVITY
and press
ENTER
•
Use the up/down arrows to select a value that is suitable (88% is a good start)
•
Select
BLOCK THRESHOLD
and press
ENTER
. This value represents the percentage of the
screen area that a detected object must occupy before an alarm is declared.
•
Select an appropriate value (3-5% is a good start) and press
ZOOM/ENTER
•
Repeat this process for channels 2-4
Exporting Video Clips to CD
Video clips may be exported to a USB storage device via the USB port on the front panel. If the
selected clips occupy more memory space than is available on the USB storage device then the backup
will be rejected and the process must be started over – so be conservative in selecting the number of
clips to be backed up. The figure below shows a USB stick and USB hard drive connected to the USB
port on the front panel. A USB CD/DVD burner with a standard device driver (does not require any
device driver software to operate) may also be used.
Figure 24: Plug in USB Storage Device.
To export clips to the installed USB storage media do the following:
•
Insert USB recording media (stick, harddrive, or CD/DVD burner) into USB port on front panel
•
Press the
SEARCH
button on the DVR panel
•
Select the
SEARCH EVENTS
option and then select a clip and start playing it back.
•
Press the
COPY
key and it will mark the start of the export.
•
When the playback has reached the point that you want to stop then:
•
Press the
COPY
key again and it will mark the stop the export.
•
Follow the screen menus to burn the selected export to USB media.