SAFERA PCU6.1-F Installation Manual - page 6

Other manuals for PCU6.1-F: Installation Manual
Manual is about: Stove Guard

Summary of PCU6.1-F

  • Page 1

    21016_01-b installation manual safera airis stove guard for pcu software versions x.X.14 and onwards pcu6.3-f pcu6.3-p pcu6.1-f pcu6.1-s pcu6.1-p.

  • Page 2

    3 2 1. Preparations contents 1. Preparations 2. Installation 3. Installation troubleshooting 4. Manual adjustment mode 5. Optional features • aux-connection • water leakage sensor follow these instructions carefully and pay particular attention to the instruc- tions marked in the following way: ѥ wa...

  • Page 3

    5 4 install the power control unit Ⓒ according to the following instructions. Installation - step 1/2 mount the power control unit Ⓒ pcu6.1-p 1-phase, 3-pin plug out. See pages 12-13. Pcu6.3-p perilex-connectors. See pages 8-9. Pcu6.1-f fixed 1-phase connection. See pages 10-11. Pcu6.3-f fixed 3-pha...

  • Page 4

    7 6 pcu6.3-f - installation fixed 3-phase connection. 42 mm 239 mm 113 mm off 1 optional aux and water sensor connections. See chapter 5. 2 6 4 3 4xa a a a b 2xb ѥ warning make sure that there is no power sup- ply to the cooker and the oven by re- moving their fuses. Also ensure that the cooker is s...

  • Page 5

    9 8 225,5 mm 95 mm pcu6.3-p - installation 3-phase, perilex-connectors. L = 700 mm 51 mm + perilex 239 mm 113 mm optional aux and water sensor connections. See chapter 5. A mount the power con- trol unit Ⓒ on the wall behind the cooker or into the cabinet next to the cooker. 2 4xa a a 3 out in on 4 ...

  • Page 6

    11 10 pcu6.1-f - installation fixed 1-phase connection. Off 1 optional aux and water sensor connections. See chapter 5. On 7 2 6 4xa a a a b 4 2xb 3 5 out 3 x 6 mm 2 l out n n l out in in pe x ѥ warning make sure that there is no power sup- ply to the cooker and the oven by re- moving their fuses. A...

  • Page 7

    13 12 pcu6.1-p - installation 1-phase, 3-pin plug. Optional aux and water sensor connections. See chapter 5. 4 3 6 4xa a a a b 2xb connect the stove with 3-pin plug. 7 2 l n/l pe in 5 239 mm 40 mm 113 mm on 8 off 1 ѥ warning make sure that there is no power sup- ply to the cooker and the oven by re-...

  • Page 8

    15 14 pcu6.1-s - installation 1-phase, schuko-connectors. 225,5 mm 95 mm l = 700 mm 46,5 mm + schuko 239 mm 113 mm optional aux and water sensor connections. See chapter 5. A a a mount the power control unit Ⓒ on the wall behind the cooker or into the cabinet next to the cooker. 2 4xa 3 out in on 4 ...

  • Page 9

    17 16 installation - step 2/2 mount the sensor unit Ⓐ mount the sensor unit Ⓐ • use the cleaning pad to remove grease and dirt from the surface before attach- ing the sensor unit Ⓐ with the adhesive tape. • mount the sensor unit Ⓐ according to the mounting option a, b or c shown on the right: if the...

  • Page 10

    19 18 problem remedy problems with checking the working order: the cooker power does not shut down • retry with the same cooker plate and ensure that the plate is set on highest power level. • with an induction cooker use a suitable dish so that the cooker is consuming power. • check all wiring of t...

  • Page 11

    21 20 table 2. The new alarm limit is indicated as shown in the table below: color of the indicator light ❹ number of beeps alarm limit red ••• ••• 12 ••• •• 11 ••• • 10 ••• 9 •• 8 • 7 blue ••• ••• 6 (default) ••• •• 5 ••• • 4 ••• 3 •• 2 • 1 ѥ warning do not set the alarm limit higher than 8 during ...

  • Page 12

    23 22 4.4 mode 4: testing and adjusting aux-connection 5. Optional features 5.1 aux-connection (optional) safera pcu6.3 and pcu6.1 power control units Ⓒ are equipped with two auxiliary out- put signals aux1 and aux2 compatible with most automation and security systems. They can be used to send real-...

  • Page 13

    25 24 5.1.3 example connection of one aux-output in this case the home automation system’s logic input is pulled to ground potential when the aux-output signal is active. Note that the maximum current pass in the optocoupler is 10 ma! The diagram illustrates the connection of one aux channel. Aux1 a...

  • Page 14

    27 26 5.2 water leakage sensor (optional) stove guard can be equipped with max. Four safera water leakage sensors. The sensors are placed in the typical leak- age areas, e.G. Under the dishwasher or sink. Attach the sensors Ⓕ in place. Attach the plug Ⓖ of the leakage sensor to the power control uni...

  • Page 15

    28.