Salter Brecknell Pegasus Floor Scale Installation Manual

1

Pegasus Floor Scale Installation Guide

Pegasus Floor Scale Installation Guide

For Shear Beam, Mild and Stainless Steel Scales and Poly Top Floor Scales

Proper scale installation provides accurate and reliable system operation. It is

essential to mount the scale on a flat, level, and solid surface. The load-

bearing surface areas should be within ±1/16 inch of the same level plane.

Minor irregularities in the floor may be compensated for with the feet adjust-

ments. The scale should not rock on the load-bearing surface areas and

these areas should not give under loads.

Figure 1

Pegasus scales

This scale is precalibrated and is ready for installation and use.

• Place the Pegasus deck on a solid, level surface. Use the leveling feet

to eliminate any rocking of the deck.

• Mount the indicator using the bracket provided. This will accommodate

desk or wall mounting.

• Uncoil the cable from under the scale and route it to the indicator. The

cable should be protected from traffic to avoid damage. Connect the

cable to the indicator. See note at left.

• Apply power to the indicator and verify proper scale performance.

Installation

Washdown systems will need to

have the cable connected to

the junction box. Use the

indicator manual to insure

proper wiring.