Summary of Handheld 9W
Page 1
Primary lighting guide.
Page 2
U s e a n d c a r e g u i d e for salvo primary dive lights © salvo, llc 705 nw santa fe boulevard high springs, fl 32643 phone 386.454.0019 • fax 386.454.1661.
Page 3: Table of Contents
Table of contents lighting innerspace -- one explorer at a time. ........................ 2 light models .............................................................................. 2 warranty information................................................................. 2 features ....................
Page 4: Lighting Innerspace --
2 lighting innerspace -- one explorer at a time. Congratulations on your new acquisition, unarguably the finest lighting equipment used worldwide by cave, wreck, reef and deep explorers. Wonderful choice you have made with your light selection. Please take a moment to read through this document. It ...
Page 5: Features
3 features all lights are delivered complete from our facility--including a fully charged battery pack, charger, and of course the light itself. Havoc ii and rebel ii primary lights • dry lid utilizing banana connector. Based on constant customer request and our commitment to manufacture the highest...
Page 6
4 is a critical (and pricey) part to your primary light; it deserves the added attention and protection. • delrin™ component construction. With the exception of the aluminum light heads on the rebel ii 21w led’s, all of our components are housed within delrin™ bodies. Delrin™ is a lightweight, low-f...
Page 7: Charging and Storage
5 charging and storage all lighting systems come fully charged from our facility; you will need to use the light before being able to charge it again. There are no customer serviceable components sealed within this pack… so, stay out of it! All warranty claims will be nullified if the internal seal ...
Page 8: Pre-Dive
6 • led will glow red while charging and will turn green when the charge cycle is completed. • it is recommended from the battery manufacturer to leave the li-pol packs partially discharged (30-50% rated capacity) when storing. Pre-dive to ensure years of dependable service from your light, follow t...
Page 9: Post-Dive
7 • when closing the locking latches, make sure to apply pressure evenly and simultaneously to the latches. • turn on the light and make sure it comes on. It is best to leave the light on for at least 30 seconds before turning off. Although the brightstar™ bulbs and ballasts are designed to be hot r...
Page 10: Changing The Bulb
8 ‘dive’ sockets. Gently slide the lid down on the canister until the o-ring makes contact with both the lid and canister. If there is resistance, stop!!, and ensure that the connectors are properly aligned. Never try to forcefully close the canister. • we recommend storing your light in a cool dry ...
Page 11
9 • carefully remove the lamp cover by gently pulling it off with a twisting motion. It is best to use a glove or wrap the lamp cover with a small towel to protect your hand from accidental breakage of the glass. Note – the 35w and 50w havoc ii hid primary lights have an additional collet and extern...
Page 12: Rebel 12 and Handheld 9
10 • connect the new bulb to the lead wires from the ballast. • reinstall the bulb into the socket. Twist the bulb with a ¼ turn as you do so to help the wires back into the socket assembly. • holding the lamp cover with a glove or towel, reinstall the lamp cover with a slight twisting motion. • the...
Page 13
11 • inspect threads and o-rings to ensure they are free from dirt and debris. • connect universal charger to wall outlet. • connect universal charger to tail piece..
Page 14
12 • led will glow red while charging and will turn green when the charge cycle is completed. • it is recommended from the battery manufacturer to leave the li-ion packs partially discharged (30-50% rated capacity) when storing. Diving the switch for the rebel 12w led and handheld 9w led primary lig...