Seeburg A6 DP User Manual - page 5
A6 dp
SEEBURG acoustic line
5
Part 1 – Connections and indicator functions
Connectors
•
XLR In: The A6 dp is controlled via a conventional symmetrical
microphone cable. For signal loop-through use the male Loop Thru
XLR In. For maximum output the connected signal source should
deliver at least 6 dBU undistorted.
•
PowerCon (grey) 230 VAC Loop Thru output. This is required if power
is to be supplied to several active speaker boxes and only one 230
Volt AC lead is being used. Please observe the maximum permitted
connected load. In practice, power can be supplied to up to two
additional systems.
.
•
PowerCon (blue): Power supply 195-250 VAC. This plug has the
same function as an on-off switch. Ensure that a 230 VAC mains
voltage is available. After switching on (clockwise rotation until it snaps
into place), the system starts up and is ready for use within 3 seconds.
Avoid continuous switching on and off, particularly when the system is
under sustained load.