- DL manuals
- Sensorsoft
- Thermometer
- ST6105C
- User Manual
Sensorsoft ST6105C User Manual
Summary of ST6105C
Page 1
Sensorsoft sensorsoft thermometer user manual models st6105j, st6105c and st6154j manual p/n 071-0014 rev 9 december 3, 2007 copyright © 1999-2007 sensorsoft corporation, all rights reserved. Sensorsoft and soft thermometer are trademarks of sensorsoft corporation..
Page 3: Table of Contents
Table of contents overview.......................................................................................................................................... 4 about this manual ......................................................................................................................
Page 4: Overview
Sensorsoft thermometer user manual overview the st6105c, st6105j and st6154j soft thermometers are rs232 compatible serial devices based on the sensorsoft device protocol. The st6105c and st6105j have a built-in temperature sensor and are intended for applications where the customer needs to monitor...
Page 5
Sensorsoft thermometer user manual installing the sensorsoft thermometer installation of the sensorsoft thermometer is composed of the following steps: • choosing an installation location • connecting the sensorsoft thermometer to a serial port • starting the sensorsoft software. Please refer to the...
Page 6
Sensorsoft thermometer user manual if you are connecting a sensorsoft thermometer to a device server please be sure to configure the port as follows: • 1200 bps, 8 bits, no parity, 1 stop bit • turn off autobaud • flow control set to none • non-telnet binary (raw) transfer mode • assert rts and dtr ...
Page 7
Sensorsoft thermometer user manual st6105c sensorsoft thermometer specifications measurement range: -40 º c to +60 º c (-40 º f to +140 º f) resolution or precision: 0.1 º c (0.18 º f) and 0.5 º c (0.9 º f) accuracy: +/- 0.5 º c (+/- 0.9 º f) over 0 º c to +60 º c (32 º to 140 º f) and +/- 1 º c (1....
Page 8
Sensorsoft thermometer user manual st6105j sensorsoft thermometer specifications measurement range: -40 º c to +60 º c (-40 º f to +140 º f) resolution or precision: 0.1 º c (0.18 º f) and 0.5 º c (0.9 º f) accuracy: +/- 0.5 º c (+/- 0.9 º f) over 0 º c to +60 º c (32 º to 140 º f) and +/- 1 º c (1....
Page 9
Sensorsoft thermometer user manual st6154j sensorsoft thermometer specifications probe measurement range : -55 º c to +125 º c (-67 º f to +257 º f) resolution or precision: 0.1 º c (0.18 º f) and 0.5 º c (0.9 º f) accuracy: +/- 0.5 º c (+/- 0.9 º f) over 0 º c to +70 º c (32 º to 158 º f) and +/- 1...
Page 10
Sensorsoft thermometer user manual resolution, accuracy and calibration the terms resolution, accuracy and calibration frequently cause misunderstanding for many individuals who have not been trained in metrology. We endeavor here to explain these terms and how they might affect your application of ...
Page 11
Sensorsoft thermometer user manual more details about the above instruments are available on vaisala's web site: http://www.Vaisala.Com keep the following points in mind when assessing the accuracy or stability of your sensorsoft device: • use one of the above recommended instruments (or equivalent)...
Page 12: Devices
Sensorsoft thermometer user manual making extension cables for c-suffix sensorsoft devices in some applications it is not possible to use pre-assembled cables. When installing the sensorsoft device at a remote location it may be necessary to run cables through walls, ceiling or conduits where connec...
Page 13
Sensorsoft thermometer user manual making communication cables for j-suffix sensorsoft devices in some applications it is not possible to use pre-assembled cables. When installing the sensorsoft device at a remote location it may be necessary to run cables through walls, ceiling or conduits where co...
Page 14
Sensorsoft thermometer user manual cable p/n c2000 9 pin serial port to sensorsoft device db-9f to rj45 modular plug 1 3 7 4 2 3 4 7 2 5 9 pin port sensorsoft device white-green white-orange white-brown blue green p/n c2000 is for use with pc’s and most other devices which have a 9 position serial p...
Page 15
Sensorsoft thermometer user manual cable p/n c2012 dce serial port to sensorsoft device db-25m to rj45 modular plug 1 3 7 4 2 3 6 5 2 7 dce port sensorsoft device white-green white-orange white-brown blue green p/n c2012 is for use with some multiport cards and terminal servers which have a dce pin-...
Page 16
Sensorsoft thermometer user manual writing programs for the sensorsoft thermometer the following describes how to write your own programs for the sensorsoft thermometer. This sensorsoft device uses a binary, packet-formatted, master-slave protocol. All data is represented in the little endian format...
Page 17
Sensorsoft thermometer user manual argument-byte the number of the sensorsoft thermometer's internal register you want to read or write. This byte is required for the temperature command. This byte is not required for the status command. Crc-bytes a two byte (16 bit) cyclic redundancy check that is ...
Page 18
Sensorsoft thermometer user manual receiving responses from the sensorsoft thermometer each response packet the sensorsoft thermometer returns is in the following format: response-byte a single byte response code indicating the type of response. Valid codes are 90 hex or 94 hex. Packetlength-bytes t...
Page 19
Sensorsoft thermometer user manual sensorsoft device status byte format bit name description 0 low power supply voltage is unacceptable for reliable operation 1 irq enable n/a 2 irq pending n/a 3 power-up sensorsoft device just powered-up 4 tamper sensor element is disconnected or broken 5 nv option...
Page 20
Sensorsoft thermometer user manual sensorsoft thermometer temperature data-byte(s) format temperature binary msb lsb hex + 125 °c 00000000 11111010 00fah + 85 °c 00000000 10101010 00aah + 70 °c 00000000 10001100 008ch + 25 °c 00000000 00110010 0032h + 0.5 °c 00000000 00000001 0001h 0 °c 00000000 000...
Page 21
Sensorsoft thermometer user manual reading the sensorsoft id record every sensorsoft device (ssd) accepts an identification (id) command, whose response can be used to uniquely identify the type of ssd currently connected. Specifically, the model number and description can be extracted from the ssd’...
Page 22
Sensorsoft thermometer user manual sample id response packet from a st6105 sensorsoft thermometer byte contents 1 2 3 4-9 10 sensorsoft (r) thermometer ~ sensorsoft corp. ~ st6105j ~ 4.00 ~ ~ 22.
Page 23: Getting Help
Sensorsoft thermometer user manual getting help limited warranty sensorsoft corporation warranties sensorsoft products to be free from manufacturing defects for a period of two years. This includes parts and labor. All shipping and brokerage fees are your responsibility when returning a sensorsoft p...
Page 24
Sensorsoft thermometer user manual 24 fcc compliance and advisory statement this equipment has been tested and found to comply with the limits for a class a digital device pursuant to part 15 of fcc rules. These limits are designed to provide reasonable protection against such interference when oper...