SMC Networks 7908VOWBRA Configuration Manual
1. To setup VoIP function, you need to collect VoIP configurations from your VoIP Service Provider:
• Phone number
• Gatekeeper IP address
• Password if security feature is required
Note: Optionally there are “Gatekeeper ID” and “H.323 ID” for additional security
2. Go to web interface under “VoIP” submenu “Port Setting”, change the “Extension Number:” to the phone number
collected from your VoIP Provider, then click “OK”
3. In the VoIP Provider Mode page, put the Gatekeeper IP address into “IP Address:”.
4. “Gatekeeper ID:” and “H.323 ID” are optional if they are available from your VoIP Provider
5. Click “OK” to save changes.
Note: If security feature is required by your VoIP Provider, select the “HMAC-SHA1-96 Authentication Only” mode in the
“Security:” drop-down menu. Also put in password into “Password:” field
6. If you encounter problems after entering the requested
parameters, please do the following:
• verify that the router is online, if not please refer to the
troubleshooting section of the QIG
• if the router is online, you should verify the different VoIP
parameters
• then consult the VoIP status page and write down the error
message
• contact VoIP provider to verify that their server is working
and the parameters are correct, then give them the error
message you get
SMC7908VoWBRA
VoIP Configuration Guide for H.323
SMC7908VoWBRA
SMC7908VoWBRA
SMC7908VoWBRA