Sri SP Series Quick Start Manual - 3. Using The Apcam App
3. Using the APCam App
3.1 Power on the IP Camera
After the camera has been powered on for 20 seconds, a beeping sound will be emitted.
This sound indicates that the network is disconnected and will require setup.
3.2 Add a camera to the APCam App
Before beginning the setup process, your phone must be connected to a WiFi network
St
ep 1: Launch the APCam App and press the “Add” button.
Step 2: Press the “SP” button to add a Sricam model from the SP series.
Step 3: Press the “Smartlink” button, then input the correct WiFi information, and any other
additional information that is required.
Once complete, the camera should emit a beeping sound indicating a successful
network setup.
Step 4: Input the camera’s password (Factory Default Password: 888888).
Step 5: Finally, press the “Save” button to complete the setup process.