1. Source Select
2. Zone LED Display
3. Page Busy
The source select button (1) is used to select the
source for the zone. Each zone has a separate
source selection button. There are 9 selectable
sources: Line sources 1 through 8 and a local
in wall mixer or source select/volume control)can
beconnected to each zone. A zone cannot select
The Single Digit Zone LED Display will display the
selected source number: lines 1-8 and local input
shown as L.
5. MlCl Priority Button
The MIC1 Priority button (5) will enable/disable
MIC1will override zones 1-8and all local inputs,
saved when the PROJECTMIX818 is switched
off,and will return to its default state on powered
back on.The default state of the MIC1 Priority is
6. Music Volume
7. Master Volume
8. MIC1 Volume
FRONT PANEL LAYOUT
Microphone source.A different local source (remote
the local source connected to another zone.Pressing
the source select button will cycle through all zones
(1). Once the display shows the desired source, press
in sequence:1, 2, 3, 4, 5, 6,7, 8, L,and OF.To select
a required source, press the source select button
the ENTER (14) buttonto confirm and the change to
the selected source.
The Zone Page Busy indicator LED (3) will illuminate
amber to indicate a paging microphone is paging to
4. MIC1 Priority Indicator
The MIC1 Priority Indicator LED (4) will illuminate
blue indicating the Zone MIC1 priority paging func
-tion is enabled.
if a signal is present on the MIC1 input.When dis
the MIC1priority paging function.When enabled,
-abled,MIC1 will mix with lines 1-8 and local inputs
if required.This Microphone input has been designed
to give global priority over all other inputs if enabled
via the front panel. The MIC1 priority setting is not
The Music Volume control knob (6) controls the
selected source (zones 1-8 and local input) input
level. If the system is used with Remote Control
Panels, the Music Volume knob will be disabled
Source Music Volume level will be controlled at the
remote control panel only.
for zones where a remote control panel is connected.
The Master Volume control knob (7) will control
the combined MIC1 and Source Output Volume
Level, if the MIC1 input has been enabled for a
zone. The Master Volume control knob will not
control the Paging Console Public Address Volume
Level,or the Line 8 Source Input Volume Level when
the Line 8 Source Input Priority Function is enabled.
This function has been designedasa global BGM
input if required.
The MIC1 Volume control knob (8) will control the
to operate within the zone. Commercial Series
PROJECTMIX818 User Manual.
MIC1 input level if this global mic has been configured
The source will only change after the ENTER (14)
button is pressed. If the ENTER(14) button is not
setting after 10 seconds.When the system is used
in conjunction with remote control panels,the zone
the source selection can only be controlled via the
source selection settings are automatically saved
and the unit will return to its previously configured
pressed,the source selection will return to previous
source select button will be disabled when a remote
controlpanel is connected to a zone .In this instance,
remote control panel in the event power is lost,the last
source selections when powered back on.