Tadiran Telecom DGL-11 Installation Instructions

Summary of DGL-11

  • Page 1

    Tgl/dgl installation instructions general ● these instructions are intended as general guidelines. The air conditioner must be installed by trained and authorized personnel. ● use the following size copper tubing for connecting the outdoor and indoor units: models tgl/dgl 9, 11 - 3/8" and 1/4". Mode...

  • Page 2

    Installing the indoor unit refrigerant line routing ● the refrigerant lines may be routed in any of the four directions shown in figure 3. Installing the mounting bracket ● pull out the mounting bracket attached to the back of the unit. See figure 4. ● position the mounting bracket on the wall and l...

  • Page 3

    Piping and display cable ● connect the ends of the refrigerant lines to their appropriate fittings, following the guidelines in the "connecting the refrigerant lines" section. ● make sure the drainage hose is at the bottom side of the wall through-hole (see figure 6). ● connect the cable labeled "di...

  • Page 4

    ● do not open service valves or remove protective caps from tubing ends until all the connections are made. ● take care to avoid kinks or flattening of the tubing. ● bend tubing with special bending tools to avoid the formation of sharp bends. ● keep the tubing free of dirt, sand, moisture and other...