Table of contents ■safety precautions…………2~3 ■applications…………………4 ■operating concepts………4 ■parts identification…………5 ■installation……………………6 ■setting up……………………7~8 ■operation……………………9 ■maintenance……………….10~11 ■servicing / specifications…11 taiji sake warmer dispenser instruction manual model : tsk-1...
Warnings: • contact a disposal service provider, municipal government office or your distributor for proper disposal of this product according to enviromental regulations. Failing to adhere to the following warnings may cause danger to human life or inflict a severe injury. Safety precautions safety...
Cautions: failing to adhere to the following cautions may result in personal injuries or property damages. • this appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given ...
This product is intended for heating sake only. The product should not be used outdoors. This product is an electric sake heater. • sake is fed into the stainless steel heat exchange pipe. • the stainless steel pipe runs through the water. • the water bath is heated by the heater. • the water temper...
Nozzle water tank overflow outlet server bottle holder control panel tray overflow outlet water level indicator accessories bottle holder funnel / bottle holder (filter inside) water tank inlet air vent urea resin screw door temperature control knob heater lamp dispensing lamp power lamp power switc...
1. Take the unit out of the shipping carton and remove all packaging materials. Check that all parts and accessories are included with the unit. 2. For installing, the location must have/be: • a level and steady surface • sufficient space for air circulation around the unit • be at least 50 cm away ...
1. Insert the power supply cord into the inlet. (fig.5) 2. Connect the power cord to an exclusive wall outlet with an ac220v-240v and 10a (minimum) power source. Do not use an extension cord. 3. Make sure the water tank overflow outlet is closed. 4. Make sure the water level in the water tank is at ...
1) remove a cap of the cubic container. 2) check the knob of the stopcock is set at the closed position. (fig. 13) then, screw it into the mouth of the container. Be sure the outlet of the stopcock facing to the right. (fig. 11) *sake will leak out if this screw-in process proceeds improperly. 3) pl...
Operation operation 1. Wait until the heater lamp goes off. After turning on the unit, the heater lamp will be lit. The sake is at the set temperature when the lamp is off. 2. Fit the nozzle (sake outlet) into the mouth of the sake server bottle into hte nozzle (sake outlet). Lightly push the bottle...
-10- maintenance maintenance daily cleaning bottle type 1. Pull out the sake bottle and drain the sake left in the dispenser. Discard the sake or you may use it for coocking. To drain sake, pull the manual switch and wait until the sake stops coming out. 2. Remove the sake server bottle holder. Plac...
Servicing servicing specifications specifications ■ for servicing of this product, please contact your distributor, nearest taiji sales representative or taiji & co., ltd. ■ if the power supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons...
( 0 9 0 8 b ) h t t p : w w w . T a i j i . C o . J p / e.
