Tangent AMP-100 Instruction Manual - page 14
POWER
OPERATION AND FUNCTIONS
Protect the environment and turn off the unit after use.
Selecting the input source
Turn on the AMP-100 by pushing one of the input buttons.
Now you can call the input source that is active at the moment. Select Tuner to listen to the radio, CD to listen to a CD, DVD, Phono,
AUX1 or AUX2 if units have been connected to these inputs.
If you do not know which input has been selected, the LCD display will clearly indicate it.
Note: All inputs are analogue stereo inputs. It means that you cannot connect a digital sound source through a digital cable (optical
or coaxial).
On, Off and standby
1. Press the Phono, DVD, CD, Tuner AUX 1 or AUX 2 button on the
remote control to select the corresponding input.
2. Press the Phono, DVD, CD, Tuner, AUX 1 or AUX 2 button on the
front panel to select the corresponding input.
1 Turn on the unit by pressing the mains switch.
2 Press the standby button on the remote control to switch into standby mode. The display
will turn off and all functions will be reduced to a minimum to make sure that the unit uses
minimal power. When in standby mode the unit only reacts to the INPUT buttons of the
remote control(3).
4 If you wish to turn off the unit to avoid any power consumption, you must press the mains
switch.
+
1
2
3
4
5
6
7
8
9
0
+10
VOLUME
PHONO
TUNER
RANDOM
AUX2
DVD
REPEAT
AUX1
CD
PROGRAM
DAB/FM
FUNCTION
AUTOTUNE
INFO
2
3
1
4
2
+
0
+10
VOLUME
PHONO
TUNER
RANDOM
AUX2
DVD
REPEAT
AUX1
CD
PROGRAM
DAB/FM
FUNCTION
AUTOTUNE
INFO
1
14