1. DL manuals
  2. TCNet
  3. Temperature Controller
  4. Boiler Controller
  5. User And Service Manual

TCNet Boiler Controller User And Service Manual

Summary of Boiler Controller

  • Page 1

    Tcnet boiler controller user and service manual developed and assembled in turkey. Türkiye’de geliştirilmiş ve üretilmiştir..

  • Page 2

    Tcnet boiler controller user and service manual 2 safety instructions caution! Schock hazard! Risk of electrical schock which may cause serious injuries or death. Please disconnect the mains before servicing this equipment. Caution! Hot surfaces! The boiler assembly and/or the temperature sensors ma...

  • Page 3

    Tcnet boiler controller user and service manual 3 (this page is intentionally left blank).

  • Page 4

    Tcnet boiler controller user and service manual 4 table of contents safety instructions ................................................................................................................................... 2 overview to control panel .......................................................

  • Page 5

    Tcnet boiler controller user and service manual 5 overview to control panel 1. Power key. 2. Input key. 3. Menu navigation key. 4. Menu navigation key. 5. Decrease parameter key. 6. Increase parameter key..

  • Page 6

    Tcnet boiler controller user and service manual 6 quick reference starting and stopping your boiler please hold the power key to either run or stop your boiler. The power state will be highlighted when you press the power key. Setting up the temperature of boiler or utility water press the input key...

  • Page 7

    Tcnet boiler controller user and service manual 7 operation menu the operation menu indicates current process values of your boiler. Large lcd display allows the control panel to show almos all temperatures measured by sensors and the calculated output power. 1. Power state: indicates the current po...

  • Page 8

    Tcnet boiler controller user and service manual 8 boiler is operating at 80%-100% of its rated power. Boiler is either performing the deflating sequence or grate cleaning sequence. 6. Device icons: auger is operating. Blower is operating. External fuel refilling system is operating. I ignition heate...

  • Page 9

    Tcnet boiler controller user and service manual 9 menu structure tcnet controller has three menu schemes for quick setup, user preferences and the service settings. The most common settings are grouped together. 1. Temperature setup: basic temperature adjust of your boiler 2. User preferences: opera...

  • Page 10

    Tcnet boiler controller user and service manual 10 operation mode to change the operation mode press adjust keys. Navigate to navigation keys and press input key to return the user preferences menu. There are three operation modes of your boiler. Mode building heating utility water 1 on on both circ...

  • Page 11

    Tcnet boiler controller user and service manual 11 -8 … -5:c -/+ 10:c -4 … -1:c -/+ 10:c 0 … 3:c -/+ 10:c 4 … 7:c -/+ 10:c 8 … 11:c -/+ 10:c 12 … 15:c -/+ 10:c 16 … 19:c -/+ 10:c >20 :c -/+ 10:c if the compensated temperature setpoint exceeds the temperature limits of the boiler, controller will inc...

  • Page 12

    Tcnet boiler controller user and service manual 12 date-time the controller panel has a realtime clock calendar. To adjust the system time and date, navigate to hour, minute, date, month, year or day of week with navigation keys. Press adjust keys to change. Controller accepts 24-hour hh:mm time for...

  • Page 13

    Tcnet boiler controller user and service manual 13 internet connectivity the controller has an onboard ethernet port to directly connect to the internet or your local area network. The lan connector of the boiler is depends on the boiler model. Please refer to the instruction manual of your boiler f...

  • Page 14

    Tcnet boiler controller user and service manual 14 after login, you should see the status page of the boiler the status page all measured temperatures and the device status are shown on this page. Cpu load indicates the current utilization of the control panel’s processor..

  • Page 15

    Tcnet boiler controller user and service manual 15 adjust the temperatures and operation mode from internet click the “temperature setup” on the menu box. Adjust the temperatures and click “submit” button. If you don’t want to make any adjustments, click “administration” from the menu and click the ...

  • Page 16

    Tcnet boiler controller user and service manual 16 setting up the week timer from internet click the “week timer” on menu box. Set up your desired start up and shut down times for each day. If you don’t want to make any adjustments, click “administration” from the menu and click the “save settings t...

  • Page 17

    Tcnet boiler controller user and service manual 17 changing the network settings click the “network configuration” on menu box. Make all required changes on network configuration and click “save config” button. Please note that the controller should reboot after changing the network settings and per...

  • Page 18

    Tcnet boiler controller user and service manual 18 turning on and turning off your boiler from internet click “administration” on menu box. Click “turn on boiler” button to turn on your boiler. Click “turn off boiler” button to turn of your boiler. Clearing errors from internet if you see any error ...

  • Page 19

    Tcnet boiler controller user and service manual 19 service menu caution! This settings are intended to be adjusted by a well trained service technician or a service engineer. Incorrect settings may cause dangerous conditions. To enter the service menu, navigate to service> with navigation keys and p...

  • Page 20

    Tcnet boiler controller user and service manual 20 boiler setup max. Power kw 25 the maximum power of the boiler min. Power kw 5 the minimum power of the boiler feed rate gr/min 380 the pellet feed amount for a minute of the auger or other fuel feeding system. Efficiency % 91 the total efficiency of...

  • Page 21

    Tcnet boiler controller user and service manual 21 power and fan speed settings for 5step modulation or fixed power. Mod1 5kw fan: 33 mod2 10kw fan: 37 mod3 15kw fan: 40 mod4 20kw fan: 43 mod5 25kw fan: 46 exh. Limit :c 150 maximum allowable flue temperature. In case of flue gases exceed the limit, ...

  • Page 22

    Tcnet boiler controller user and service manual 22 graph 2 5 step modulation graph 3 fixed power regulation tuning the pid modulation: - if your boiler never reaches the setpoint, increase the mod1 power level. - if your boiler exceeds the setpoint more than the hysteresis value, decrease the mod1 p...

  • Page 23

    Tcnet boiler controller user and service manual 23 graph 4 feed period ignition data feed time sec 60 timeout min 10 retries 3 burn. Detect temp :c 100 burn. Detect delta :c 7 [graph5] auger filling min 3 first run 0 fan speed 50 graph 5 burning detection and deflating cycle circulation data heating...

  • Page 24

    Tcnet boiler controller user and service manual 24 hysteresis 2 util. Water circuit threshold 35 hysteresis 2 network status ip address 192.168.1.127 the ip address of the controller subnet mask 255.255.255.0 the subnet mask of the controller default gateway 192.168.1.1 the default gateway address (...

  • Page 25

    Tcnet boiler controller user and service manual 25 digital inputs in0: off in4:off the input signals of the controller. Off : no signal / open on: signal / close in1: off in5: off in2: off in6: off in3: off in7: off analog inputs t3 (boiler temp. Sensor) lm (lambda sensor)* the measured values of th...