U&I U&I-03 User Manual - page 13

Manual is about: Bluetooth

Summary of U&I-03

  • Page 1

    U&i-03/u&i-04/u&i-05/u&i-07 bluetooth headset user manual (v2.0+edr version) bluetooth.

  • Page 2: Contents

    Contents 1、introduction..................................................................................... Bluetooth headset technology............................................................. 2、charging and basic operation.......................................................... The headset ...

  • Page 3: 1.Introduction

    1.Introduction bluetooth headset(u&i-03 、 u&i-04 、 u&i-05 、 u&i-07) can be used with compatible phones that support bluetooth wireless technology. This allows you the freedom to make and receive calls while on any time and any where. Read this user manual carefully before using the headset. Read als...

  • Page 4: The Headset Structure Sketch

    2.Charging and basic operation the headset structure sketch the headset contains the following parts: 1-- multifunction button(mfb) 2-- led indicator 3-- microphone 4-- volume down key ( vl- ) 5-- volume up key (vl+) 6-- ear hook 7--speaker 8--charger socket 9--ear cap ( u&i-03 / u&i-04 / u&i-05 ) r...

  • Page 5: U&i-04

    U&i-04 u&i-05 1 1 2 2 3 3 4 4 5 5 6 6 7 7 8 8 9 9 10 10 3 ed413159axx-v2.0

  • Page 6: U&i-07

    U&i-07 1 2 3 4 5 6 7 8 9 10 before you can start to use the headset, you must charge the battery, and pair the headset with a compatible phone. 【 note】 : parts of the headset are magnetic. Metallic materials may be attracted to the headset. Do not place credit cards or other magnetic storage media n...

  • Page 7: Chargers and Batteries

    Chargers and batteries check the model number of any charger before using it with this device. 【 warning】 :use only batteries and chargers approved by manufacturer for use with this particular enhancement. The use of any other types may invalidate any approval or warranty, any may be dangerous. For ...

  • Page 8: Note

    Connect the charger to a wall outlet or the car charger (options) to the accessory power outlet of your car. The red indicator light turns on during charging.(if you do not use the headset for long periods, causing the battery out of power completely,the red led will not light, it’s also normal).The...

  • Page 9: Turning On & Off The Headset

    The longest continued talking time after the headset is fully charged: however, the talking and standby times may vary when used with different mobile phones, products that use a bluetooth connection, usage settings, usage styles, and environments. When the headset is running out of battery, it will...

  • Page 10

    Pairing the headset with a compatible device 1. Turning on your phone and activate the bluetooth function on the phone. (see the user guide of your phone for instructions). 2. Now please turn on the bluetooth headset, the blue led will flash for 4 times, then automatically enter into the pairing mod...

  • Page 11: Disconnecting The Headset

    Disconnecting the headset to disconnect the paired headset from your phone (for example, to connect the phone or headset to another bluetooth device), turn off the headset, or disconnect the headset from the bluetooth menu of your phone. You do not need to delete the paired headset from the phone in...

  • Page 12: Basic Use

    3. Basic use wearing the headset the headset is ready to wear on the right ear ( pic. 1). If you want to use it on the left ear, please softly lift up the earhook ( pic 2 ) and rotate it ( pic. 3), and push it back to the suitable place , then wear to your ear( pic. 4). 1 2 3 4 1 2 3 4 1 2 3 4 u&i-0...

  • Page 13

    Adjusting the headset ear hook the ear hook can be adjusted to suit the different ear size and make you feel comfortable. U&i-07 u&i-07 u&i-05 u&i-03 u&i-04 1 2 3 4 for u&i-03,u&i-04 and u&i-05 headset, you can use the ear cap if you don't like the ear hook. Just take off the ear hook and put the ea...

  • Page 14: Warning

    【 warning 】 : make sure not to distort the ear hook always for a long time with large extent while adjusting the hook, otherwise may damage the ear hook. Press the vl+key to increase or the vl-key to decrease the volume. 【 note 】 : there are 15 volume levels available for adjusting to high or low, w...

  • Page 15: To End A Call

    To end a call to end the current active call, press the headset mfb or press the ending key on your phone. To mute or cancel mute of microphone to mute the microphone during a call, press the headset mfb and vl+key simultaneously until it beeps. Repeating this operation can cancel the mute function....

  • Page 16: Resetting The Headset

    Resetting the headset under following status you have to reset the headset: headset still does not work afer being fully charged. Headset software needs reset. Plug the charger to the headset and charge it for seconds to restart (normally such situation seldom happens). Troubleshooting if you can't ...

  • Page 17: 4. Battery Information

    4. Battery information this headset is powered by rechargeable battery. The new battery can achieve the best function only after two or three times fully charged and discharged cycles. But it eventually will be invalid after being charged and discharged for hundreds of times. You only can charge the...

  • Page 18: 5. Terms Interpretation

    5. Terms interpretation pairing: verify between the two devices (bluetooth headset and mobile phone) connect: the two devices build up connection for communication after been approved by each other. 【 note】 : normally, only need to make paring between the two devices once, but connection will not on...

  • Page 19: 6. Appendix

    6. Appendix appendix 1: replacing the faceplate for u&i-03 how to take off the headset faceplate: fig.A: loose the faceplate from the top joint (please refer to the following pictures showed). Fig.B: draw out the faceplate (please refer to the following pictures showed). Fig.A fig.B 17 ed413159axx-v...

  • Page 20: How to Put On The Faceplate:

    How to put on the faceplate: fig.A: put the faceplate in the right place of the headset (please refer to the following pictures showed). Fig.B: fasten the faceplate into the headset board. Fig.C: completion. Fig.A fig.B fig.C 18 ed413159axx-v2.0

  • Page 21: Appendix 2: Specification

    Appendix 2: specification model no solution csr(stands for cambridge silicon radio ltd-uk) bluecore4-audio rom v2.0 + edr 2.4ghz~2.4835ghz ism band 45mw 0dbm 2mbps ~ 3mbps 0000 up to 10 meters(30 feet) 5ma~20ma 3.6v rechargeable li-polymer battery 12g l58xw23xh12 l48xw21xh12 l46xw20xh12 l59xw24xh11 ...

  • Page 22: Led

    Appendix 3: indicator led status led blue red red & blue status flashing continued 4 times turning on mode standby mode before pairing standby after successful pairing data transferring mode or on a call turning off mode charging status indicating low battery pairing mode (last for about 5 minutes) ...

  • Page 23: Operation

    Appendix 4: operation statement operation turning on part 1 turning off pairing answering a call long press the mfb key for 2 seconds long press the mfb key for 5 seconds with the headset on, it will go into pairing mode automatically press the mfb key red and blue led flash in turn the blue led fla...

  • Page 24: Methods

    Methods status part 2 decreasing the volume press vl-key ending a call press mfb key hearing a beep redialing press vl+key for 3 seconds automatically redial the last number you called after hearing a beep operation hearing a beep and both red and blue led flash 1 time each,total 15 volume levels av...