V-Data VED-M Operation Manual

Summary of VED-M

  • Page 1

    693 melrose road lottsburg, va 2251 vdata@crosslink.Net video encoder/decoder model ved-m operation manual description the video encoder/decoder (ved) model ved-m has two modes of operation, encode and decode. When gps data from an external gps receiver is available, the ved automatically enters the...

  • Page 2: Encode Mode

    2 encode mode on power-up the ved begins searching for either gps input or edge-coded video input to determine whether to enter encode or decode mode. If gps data is detected the ved enters the encode mode and begins inserting alpha-numeric data and edge-code data into the video. Once the encode mod...

  • Page 3: Decode Mode

    3 decode mode if gps input is not present on power-up, the ved will enter the decode mode when edge- coded video is detected. In the decode mode, gps data is output in rs-232 form (4800 baud, 8 data bits, 1 stop bit, no parity) each time the edge-code changes, which is normally once per second. If t...

  • Page 4: Gps Receivers

    4 gps receivers v-data can supply 12 channel gps receivers by garmin international. The receiver, designated gps-35v, has integrated antenna, 16 foot cable, and ved compatible db15m connector. Mounting options including magnetic, suction cup behind windshield, permanent flange, and 1 inch 14 tpi mar...