Vac Pro ALI-VAC1 Installation & Operating Instructions Manual - page 10
8
INSTALLATION AND OPERATING INSTRUCTIONS
1. Ensure canisters are clean and dry.
Note: Do not immerse canister
lids in water, wipe with a damp
cloth only.
2. Remove Vacuum Seal Hose from
Roll Storage Compartment lid (see
Fig 8) and ensure Vacuum Seal
Cover is closed but not locked
on unit.
3. Fill canister with the item to be preserved and secure lid onto
the canister.
Note: Leave at least one inch from canister cover rim, and
make sure upper lid is already locked before vacuuming.
4. Turn canister lid dial arrow to SEAL.
5. Connect one end of the Vacuum Seal Hose to the Vacuum Seal
Hose Port, ensure connection is pushed in tightly (see Fig 9).
6. Connect the other end of the Vacuum Seal Hose to the Vacuum
Seal Canister Lid ensure connection is pushed in tightly
(see Fig 9).
7. Press the Canister Button to draw out air from Canister through
hose attachment. Vacuum action will stop automatically when
all air has been drawn out from canister.
Note: If canister is not vacumable and sealable for some
unknown reason, the vacuum system will shut down
automatically after 2 minutes.
8. Remove Vacuum Seal Hose connection to the canister.
9. Repeat steps 2-6 for other canister to be sealed.
10. When all canisters have been sealed remove Vacuum
Seal Hose Port and store back inside the Roll Storage
Compartment lid.
Note: Canister lids are not to be used in microwaves or in freezers.
11. To open Canister after vacuum
packaging, turn the canister
lid dial arrow to OPEN. Wait
several seconds for the lid to be
released before removing.
Fig 8
Fig 9
C. Preserving Food in Canisters