VacuMaid EB-210 SuperGroom II Model Manual

Summary of EB-210 SuperGroom II Model

  • Page 1

    Eb-210 eb-210 eb-210 eb-210 eb-210 12” electric brush 12” electric brush 12” electric brush 12” electric brush 12” electric brush f f f f fea ea ea ea eatur tur tur tur tures inc es inc es inc es inc es include: lude: lude: lude: lude: • 3-level height adjustment--adjusts to match surface being clea...

  • Page 2: Wand Insertion and Release

    Electric brush assembly & use wand insertion and release warning ! Do not attach or remove handle or wands while cleaner is on. This could cause sparking and damage the electrical contacts. For the eb-210--insert wand, snap wand button into place. Turn wand button past the stop position. This slotte...

  • Page 3

    5 eb-210 supergroom ii™ care electric shock hazard disconnect electrical supply before servicing or cleaning the unit. Failure to do so could result in electrical shock or personal injury. Light changing eb-210 supergroom ii™: 1. Remove light cover by pressing in and lifting both sides as shown. 2. ...

  • Page 4

    3. Turn eb-210 supergroom ii™ right side up. Tilt cover forward from back until front snaps free. 4. Carefully insert and lift screwdriver at each brush support to free brush from base. 5. Remove belt from motor shaft. To replace: 1. Slide on washers and brush supports. 6. Remove broken or worn belt...

  • Page 5

    3. Insert both front support tabes into base slots. Then snap brush supports into place. Front support tab 4. Line up tabs on front of base with slots inside the cover front. 5. Tilt cover to back. Press cover firmly until rear tabs snap into place. Turn eb-210 supergroom ii™ over, replace the cover...

  • Page 6

    3. Insert both front support tabes into base slots. Then snap brush supports into place. Front support tab 4. Line up tabs on front of base with slots inside the cover front. 5. Tilt cover to back. Press cover firmly until rear tabs snap into place. Turn eb-210 supergroom ii™ over, replace the cover...

  • Page 7

    3. Turn eb-210 supergroom ii™ right side up. Tilt cover forward from back until front snaps free. 4. Carefully insert and lift screwdriver at each brush support to free brush from base. 5. Remove belt from motor shaft. To replace: 1. Slide on washers and brush supports. 6. Remove broken or worn belt...