Vt170esc & vt190esc nema 4x enclosed all-in-one computer user’s guide read these instructions completely before attempting to operate your new color display user manual solutions for demanding applications industrial crt and flat panel displays vartech s y s t e m s i n c..
Vt170 & 190esc 2 150-113 model number: vt170esc ______ (17” display) vt190esc ______ (19" display) serial number: ________________________________ copyright © 2006. All rights reserved. January 2006.
Vt170 & 190esc 3 150-113 table of contents chapter 1: introduction and overview 4 esc series industrial computer 4 using this manual 4 safety information 4 receipt of system components 4 overview of system features 4 nema 4x enclosure 4 cooling system 4 shock resistance 4 electrical protection 4 tec...
Vt170 & 190esc 4 150-113 chapter 1: introduction and overview esc series industrial computer using this manual this manual covers installation and service of components, enclosures and cooling systems. •chapter 1 introduction and overview •chapter 2 installation •chapter 3 maintenance and repair •ap...
Vt170 & 190esc 5 150-113 figure 1 esc series computer technical specifications fans dual 50 cfm (19 lps) 12 vdc, 230 ma stainless steel ball bearings; locked rotor and polarity protected operating temperature range: –10°c to 70°c ul yellow card recognized; csa certified environmental temperature (pe...
Vt170 & 190esc 6 150-113 chapter 2: installation installation requirements mounting hardware supplied for easy installation. When determining the location for mounting, keep in mind the weight of the unit, available power connections, and access to peripheral equipment necessary for system operation...
Vt170 & 190esc 7 150-113 2) make certain the unit mounting hardware is not compromised by the rack or cabinet installation. 3) verify that the connection of the equipment to the supply circuit does not overload the circuit, and that a reliable earth ground is maintained for the power connection. Oth...
Vt170 & 190esc 8 150-113 1) identify the specific location and position at which the unit is to be installed. Make sure to allow sufficient clearance for conduit and/or cable connections. Mark the mounting surface where the top edge and one side of the enclosure will be aligned. 2) the mounting poin...
Vt170 & 190esc 9 150-113 these standard connectors are intended to be used with flexible, nonmetallic conduit or tubing. It is strongly recommended that computer installations include a flexible section of conduit, for example, three feet of conduit or two feet of tubing to allow the shock and vibra...
Vt170 & 190esc 10 150-113 caution! The incoming power switch must be set correctly before powering the computer. Failure to do so may cause serious damage to the equipment and or injury to personnel. 4) connect the ground wire to the ground stud in the bottom of the enclosure as shown in figure 2. A...
Vt170 & 190esc 11 150-113 chapter 3: maintenance and repair very little maintenance is required. The enclosure is watertight but should be checked regularly to ensure that all components are operating properly. Contact vartech for assistance and/or to order spare parts. Cleaning systems are housed i...
Vt170 & 190esc 12 150-113 appendix a: support information vartech systems technical support for technical support and repairs, please contact vartech systemstechnical support at: (800) 223-8050 or (225) 298-0300, monday through friday, 7:00 am to 4:30 pm cst, excluding holidays. Fax: (297) 297- 2440...
