1 w ir e le s s c y c le c o m p u te r wireless cycle computer installation and operation manual i iii ii i i ii 213 bracket computer 2131 bracket & sensor 213/2131 bracket seat cable ties rubber slip vs-2131 wired vs-213 wireless wired cycle computer vs 213 vs 2131.
Ins ta l l at io n p a rt 1 how to install the computer use a coin to turn the battery compartment anti-clockwise to fit the cr2032 battery. Check that the + sign is facing upwards. Reseal and tighten the compartment. How to install the battery (fig b) installing the bracket seat use two cable ties ...
4 fig.E bracket lever pu ll in pu sh ou t how to install the computer bracket add rubber slips to fix the by two ties to the bicyc le handlebar (fig d) bracket c omputer ins ta lla tion slide the computer into the bracket through the slot as fig.E. Press the lightly until the computer locks. Fig.D n...
● the sensor should face the computer, the distance between sensor and computer should be no more than 90cm(refer to fig.M), the angle should be no more than 30 ° (refer to fig.N). 6 7 fig. M fig. N m ax 9 0c m max 30 ° please test the computer to see if it works well after installation. If necessar...
1.Wheel size in inch circumference = diameter x 25.4 x 3.1416 2.Wheel size in mm circumference = diameter x 3.1416 9 f u nc t io ns of vs - 213 & vs - 2131 wheel cir . ( mm ) dimens ion marked in the wheel b u t t o ns 1.Mode 2.Set 16x1.75x2 20x1.75x2 24x1 3/8 a 24x1.75x2 26x1 26x1.5 47-305 47-406 3...
10 wheel cir . ( mm ) wheel cir . ( mm ) 26x1.6 26x1.75x2 26x1.9 26x2.00 26x2.125 26x1 3/8 26x1 3/8x1 1/2 26x3/4 27x1 1/4 27x1 1/4 fifty 28x1.5 28x1.75 28x1 1/2 28x1 3/8x1 5/8 700x1 8c 700x20c 700x23c 700x25c 700x28c 700x32c 700x35c 700x40c 47-559 50-559 54-559 57-559 37-590 37-584 20-571 32-630 28-...
12 13 fig.P set+mode 2s mode for changing from low to high mode for changing from hour to minute km/h mode mode mode mode km/h 2074 km/h spd km/h km/h set speed unit set circumference 12hr/24hr set clock note: how to use the bicycle computer 1. To enter into set up mode, replace the battery or press...
3.Press mode again and switch to the display as fig. S: i.Upper line shows that your current riding speed is 20.2km/h. Ii.Lower line shows that your riding time is 30 minutes 20 seconds. I i i . I t w i l l s t o p c o u n t i n g automatically if there is no signal received over 6 seconds. 4.Press ...
Fig.V 1.The bicycle computer is water-resistant and can be used in light rain showers. 2.The battery for the sensor and computer can be used for 1 year if it is used for 2 hours each day. 3.The maximum space between bicycle computer and sensor should be 90cm, a nd the angle s hould not be over 30°. ...
18 ■ trouble-shooting guide p r o ble m c a u s e s o lu tio n re-install the computer re-install the battery correctly or replace the battery no power in sensor or computer the computer can not receive any signal incorrect computer installation position faulty speed display other strong signals int...
