- DL manuals
- Remote Control
- EXMITTER EX6
- User Manual
VolantexRC EXMITTER EX6 User Manual
Summary of EXMITTER EX6
Exmitter -- professional remote control products expert.
Page 2: Warning
2 exmitter ex6 digital radio system the following terms are used throughout the product literature to indicate various levels of potential harm when operating this product. Caution: procedures, which if not be properly followed, is able to create a possibility of physical property damage and or poss...
Page 3: Transmitter Details
3 exmitter ex6 digital radio system channel 6 rudder trim dual rate function mix-function swiches indicator led servo reverse swiches throttle trim 3-switch channel 5 on/off switch transmitter details aileron trim elevator trim.
Page 4: Install Batteries
4 exmitter ex6 digital radio system remove the battery cover and install 4 aa batteries. Make sure the polarity of each corresponds with the diagram in the battery holder. Replace the battery cover. Install batteries ex7 uses one-button on/off switcher. Press the button for 1 second to turn on the t...
Page 5: Install Your Receiver
5 exmitter ex6 digital radio system install the receiver in your vehicle using double-sided velcro. Velcro will hold the receiver in place and help isolate it from vibrations. Mount the antenna up and away from the vehicle in an antenna tube. The higher up the antenna is, the better signal it will r...
Page 6: Failsafe Setting
6 exmitter ex6 digital radio system failsafe setting the ex6 comes with the receiver failsafe set to none. In the event of loss of signal the motor will stop and the vehicle will willdrift. If the signal is regained normal function will return. If you wish to program the failsafe to a custom setting...
7 exmitter ex6 digital radio system auto pilot mode logical mixing the ex6 allows mixing function in auto pilot mode. To achieve this function, just simply follow below steps: 1. Switch drone to on position 2. Six functions customizable to match your auto pilot system: 1) dual rate function switcher...
Page 8: Digital Trims
8 exmitter ex6 digital radio system the ex6 features digital trims. Each time a trimmer is moved the servo output will change one step. If the trimmer is held, the output will scroll in that direction until the trimmer is released or the output reaches its end. Digital trims throttle trim rudder tri...
Page 9: Manual Calibration
9 exmitter ex6 digital radio system manual calibration throttle trim elevator trim if the controlling performs not perfectly as you expected, try to recalibrate it manually by following below steps: 1. Hold the elevator trim&throttle trim at upper position while power on the transmitter to enter man...
Page 10: Perform Range Check
10 exmitter ex6 digital radio system perform range check as a precaution, an operational ground range check should be performed before the first flight each time out. Performing a range check is a good way to detect problems that could cause loss of control such as low batteries , defective or damag...
11 exmitter ex6 digital radio system 2.4ghz trouble shooting guide problem possible cause solution the system is not connected your transmitter and receiver are too close take transmitter 1 to 3 meters away from receiver you are around metal objects try in an area with less metal around the model se...
12 exmitter ex6 digital radio system © 2014 2015 volantexrc co.,ltd..