Walka Handheld TV User Manual - page 7

Summary of Handheld TV

  • Page 1

    User guide 1.2 handheld tv.

  • Page 2

    23 contents introduction walka handheld tv walka components charging your walka activate your walka basic functions advanced functions settings aspect ratio channel scan resetting your walka updating the firmware setting the time zone 4 5 6 10 11 13 15 17 18 19 20 22 23 setting the time zone please ...

  • Page 3

    Dstv mobile terms & conditions must be accepted to use this device. You can view the terms and conditions and/or the end user licence agreement by doing the following; 1. Go to apps.Dstvmobile.Com/decoder/terms 2. Email care@dstvmobile.Com 3. Visit your local dstv service centre and request a copy o...

  • Page 4

    21 4 ! Factory reset (hard reset) in the event that the soft reset does not work, then it might be necessary to perform a factory reset. To do this, hold down the power button for 5 seconds while inserting a paper clip into the reset hole on the left of the device. Then release the power button and ...

  • Page 5

    Resetting the walka (soft reset) if you experience an error with your walka, you can reset it. To do this, you will need to locate the reset point on the right side of the device. Insert a paper clip into the hole. Once the device screen goes to black, remove the paperclip and the device will restar...

  • Page 6

    6 1. Viewing screen front walka components channel scan in the event you lose reception while in a coverage area, you will be able to re-acquire the signal by rescanning for channels. Do the following: 1. Extend the antenna. 2. Click on the menu/ button. 3. Click the channel up/down buttons to selec...

  • Page 7

    Walka components 2. Retractable antenna for receiving the signal. Important: extend and position vertically to improve signal reception. 3. Speaker back 7 aspect ratio aspect ratio refers to the height and width of the video on the screen. You are able to change the aspect ratio settings on the walk...

  • Page 8

    Walka components settings you are able to adjust a number of settings on the walka, these include the brightness, contrast and colour. To adjust the screen settings do the following: 1. Click on the menu/ button. 2. Using the channel up/down buttons to scroll to the settings menu item. 3. Choose bri...

  • Page 9

    Walka components 4. Power button. Pressing and holding the power menu button will turn the device on or off 5. Volume down button 6. Volume up button 7. Headphone port 8. Serial number 9. Ca number 10. Reset button 11. Charge status led, if the led is green then the device is charged if the led is r...

  • Page 10

    Charging your walka the walka comes partially charged. There are 2 ways to charge the walka. Please note: charging via a power point is faster than charging via the usb port on your computer. 1. Use the provided usb cable and charger. 2. Use the provided usb cable and plug the device into an availab...

  • Page 11

    Activate your walka before you can view mobile tv on your walka, you must activate your device with dstv mobile or gotv mobile. You can activate your walka using one of the options listed below. Option 1: go to dstvmobile.Mobi on your mobile phone, or http://www.Dstvmo- bile.Com for a list of activa...

  • Page 12

    Basic operation 1. To power the device, press and hold power button until the lcd is turned on and you see the ‘walka’ screen. 2. You will be prompted to accept the end user licence agreement and the terms and conditions of the service. (see page 3 for details). Please note: you may only view mobile...