Walker Bay 275 RID Assembly Instructions Manual - page 6

Summary of 275 RID

  • Page 1

    275 rid ™ assembly instructions web: www.Walkerbay.Com email: info@walkerbay.Com ® parts list (specifications and contents subject to change without notice) description part # a. Rid track ...............................................2000010520 part no. 1000130023 v.2 lscsep01 d. Bolts* (10-32 x 5...

  • Page 2

    Tools you will need: remove paper template. Drill with bit #11 [3/16] screwdriver retrofit rid track assembly instructions for non rid ready boats cut out template on corner of page. Align port (left) template with outside of port gunwale lip and first rib on aft edge. Using a drill gun & bit #11, d...

  • Page 3

    On assembled boat, locate rid plugs along each side of the hull. Gently tap rid plugs out with a hammer. Once rid plugs are dislodged, carefully pry plugs out with claw of hammer to secure track to hull, insert bolt and washer from inside of hull and nut from outside of hull. Track rid track assembl...

  • Page 4

    Tube installation instructions if alone, try sliding tube on with boat upside down. Partially inflate tube (1/4 full) and apply liquid soap and water to track runner on tube to help feed tube into track with greater ease. Begin by sliding both sides of tube halfway down first track set. (as after in...

  • Page 5

    After installing the second set of tracks proceed with the front set of tracks. Using wrench provided in repair kit, hand tighten each valve. Do not over tighten valve. Inflate chambers in sequence shown until wrinkles disappear. Peel backing from capacity plate and apply new plate on inside of the ...

  • Page 6

    Caution ! Caution ! Do not use oily or abrasive substances. Do not use products that contain: phosphates, chlorine, solvents, non- biodegradable or petroleum based products. Do not use armor all® automotive cleaning agent and preservative on tube. Read labels and instructions carefully to avoid prod...

  • Page 7

    Caution ! For large tears or repairs to seams or bulkheads it is recommended that the tube be returned to your local dealer for repair by a trained profesional. Tube repairs for repairs, parts, or service contact your local dealer. Large repairs to skin - seams - bulkheads small tears - cuts - punct...

  • Page 8: Rid Retrofit Template

    Rid retrofit template port (left) side rid retrofit template starboard (right) side.