1. DL manuals
  2. Walker Bay
  3. Boat
  4. 275H
  5. Assembly Instructions Manual

Walker Bay 275H Assembly Instructions Manual

Summary of 275H

  • Page 1

    Rid ™ :275r, 275h assembly instructions walker bay boats inc. 717 butterfield rd, yakima, wa 98901, usa toll free phone (u.S.A & canada) 1-888-44walker (449-2553) or 604-682-5699 fax (u.S.A & canada) 1-888-228-7222 or 604-683-1877 web: www.Walkerbay.Com email: info@walkerbay.Com rid kit part #91701 ...

  • Page 2

    ! $ & ! % & " bow section aft section fasten nut tightly 4%-0,!4% 4%-0,!4% tools you will need: remove paper template. Drill with bit #11 screwdriver retrofit rid track assembly instructions for non rid ready boats cut out template on corner of page. Align port (left) template with outside of port g...

  • Page 3

    ! On assembled boat, locate rid plugs along each side of the hull. Gently tap rid plugs out with a hammer. Once rid plugs are dislodged, carefully pry plugs out with claw of hammer to secure track to hull, insert bolt and washer from inside of hull and nut from outside of hull. Rear track, port aft ...

  • Page 4

    Do not force tube into track. Use care when feeding tube runner into track. 8 ( ' tube installation instructions if alone, try sliding tube on with boat upside down. Partially inflate tube (1/4 full) and apply liquid soap and water to track runner on tube to help feed tube into track with greater ea...

  • Page 5

    Using wrench provided in repair kit, hand tighten each valve. Do not overtighten valve. Inflate chambers in sequence shown until wrinkles disappear. -!8 03) bar peel backing from capacity plate and apply new plate on inside of the stern, over top of existing plate. Warning ! Tube provides flotation ...

  • Page 6

    Caution ! Caution ! Do not use oily or abrasive substances. Do not use products that contain: phosphates, chlorine, solvents, non- biodegradable or petroleum based products. Do not use armor all® automotive cleaning agent and preservative on tube. Read labels and instructions carefully to avoid prod...

  • Page 7

    Caution ! For large tears or repairs to seams or bulkheads it is recommended that the tube be returned to walker bay® or your dealer for repair by a trained professional. Contact walker bay® customer service for return authorization, repair service and freight rates. Tube repairs for repairs, parts,...

  • Page 8: Rid Retrofit Template

    Rid retrofit template port (left) side rid retrofit template starboard (right) side.