1. DL manuals
  2. Walker Bay
  3. Boat
  4. 310H
  5. Assembly Instruction Manual

Walker Bay 310H Assembly Instruction Manual

Summary of 310H

  • Page 1

    Rid ™ :310r, 310h assembly instructions walker bay boats inc. 717 butterfield rd, yakima, wa 98901, usa toll free phone (u.S.A & canada) 1-888-44walker (449-2553) or 604-682-5699 fax (u.S.A & canada) 1-888-228-7222 or 604-683-1877 web: www.Walkerbay.Com email: info@walkerbay.Com parts list (specific...

  • Page 2

    Cm very important! Note: before you begin the installation process, make sure your boat hull is completely stabilized. The boat should not be able to move freely in any direction. Tools and equipment: a 7/16” nut driver to remove seat bolts. One was supplied with your boat and its assembly instructi...

  • Page 3

    Step 4: reinstall screws into gunwale cap. Do not tighten completely step 5: insert track into gunwale with the capped end facing the bow of the boat. Step 6: reinsert gunwale cap into the gunwale with the track firmly against the hull of the boat. Step 7: reinstall screws into gunwale cap, hand tig...

  • Page 4

    Repeat steps 1-7 on starboard (other) side of boat. Step 9: insert bow gunwale cap unto the gunwale, insert screws and hand tighten until snug. Do not over tighten screws 8 step 10: remove 2 seat bolts from the bow and stern seats. Replace with davit lifting eyebolts. #.

  • Page 5

    Do not force tube into track. Use care when feeding tube runner into track. If alone, try sliding tube on with boat upside down. Partially inflate tube (1/4 full) and apply liquid soap and water to track runner on tube to help feed tube into track with greater ease. Begin by sliding one side of tube...

  • Page 6

    Using wrench provided in repair kit, hand tighten each valve. Do not over tighten valve. Inflate chambers in sequence shown until wrinkles disappear. Peel backing from capacity plate and apply new plate on inside of the stern, over top of existing plate. -!8)-5-#!0!#)4)%3 53#/!34'5!2$ 8 0%23/.3/2xxx...

  • Page 7

    Caution ! Caution ! Do not use oily or abrasive substances. Do not use products that contain: phosphates, chlorine, solvents, non- biodegradable or petroleum based products. Do not use armor all® automotive cleaning agent and preservative on tube. Read labels and instructions carefully to avoid prod...

  • Page 8

    Caution ! For large tears or repairs to seams or bulkheads it is recommended that the tube be returned to walker bay® or your dealer for repair by a trained professional. Contact walker bay® customer service for return authorization, repair service and freight rates. Tube repairs for repairs, parts,...