Summary of CG-605L
Page 1
Operating instructions model cg-605l caulking gun.
Page 2: Charging Time
Model no cg-605l voltage 18v d.C capacity 600 ml expel force 740 kgf/7252n/1628 lb no-load speed 1.5~10 mm/sec tool weight (excluding battery) 2.5 kg battery weight 0.7 kg vibration 0.30 m/s 2 noise 72.8 db 18.0v 3.0ah wlc-uni 60 minutes auto cut-off view of the major components & accessories techni...
Page 3: Warning!
General safety rules warning! Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in an electric shock, fire and/or serious injury. Save all warnings and instructions for future reference! The term “power tool” in the warnings refers to your main...
Page 4: 4. Power Tool Use and Care
General safety rules (continued) product safety instructions 4. Power tool use and care - do not force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. - do not use the power tool if the sw...
Page 5: Warning!
Charger electrical safety warning! Read and understand all instructions. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. • before using battery charger, read all instructions and cautionary markings in this manual, on battery charge...
Page 6: Warning!
Additional precautions for charger & battery pack warning! Only charge batteries designed for use with this charger. Charge only wlb-18v wallpro batteries with the wlc-uni wallpro universal li-ion battery charger. • do not attempt to use a step-up transformer, an engine generator or dc power recepta...
Page 7: Charging The Battery Pack
Charging the battery pack • connect the plug to the charger before charging. • plug the fast charger into the power source. • slide the battery pack into the charger as the arrow direction shown on the charger. • push the battery pack into place and make sure the red light on the charger is “on”. Th...
Page 8: The Led Light On The Charger
Battery pack led indication function (optional) the battery pack has a “sw” button and 4-step green leds for indicating remaining capacity status. The fuel gauge green led will indicate when the “sw” button is momentarily pressed. The led light on the charger power on (green light flashes slowly) ba...
Page 9: For Sausage Bag Application
Tool operation for sausage bag application fig. 4 plunger disk plastic plunger disk approx. 2 cm across 2.Remove the front cap. Fit the nozzle inside the front cap and cut off the tip at a point suitable for the job. 3. Insert the sausage bag into the compound holder. Screw the front cap on tight. I...
Page 10: For Cartridge Application
Tool operation (continued) for cartridge application fig. 7 plunger disk rack fig. 8 fig. 9 fig. 10 fig. 11 front cap m8 x 16 screw plastic plunger disk rack plunger disc pushing block m8 x 16 screw rack plastic plunger disk plunger disk compound holder 1. Firstly untighten and remove the compound h...
Page 11
Parts diagram and list no parts name qty cg5-1 front cap 1 cg5-2 compound holder 1 cg5-4 screw 12 cg5-11 connector 1 cg5-13 connecting cap 1 cg6-3 plunger screw 1 cg5-5 plunger cover 1 cg6-6 plastic plunger disk 1 cg6-7 plunger disk 1 cg6-9 plunger adaptor screw 1 cg6-8 spring 1 cg6-14 rack 1 6-3 5-...
Page 12
No parts name qty cg5-16 gear box assembly & rack guider 1 cg5-23 pcb assembly 1 cg5-21 speed control dial 1 cg5-20 rack release button 1 cg5-22 spring 1 cg5-27 rack release rod assembly 1 cg6-24 motor screw 1 cg6-25 motor fixing ring 1 cg5-26 motor assembly 1 cg5-37 screw 1 cg5-38 gear 2 cg5-39 was...
Page 13
Symbols • on the product, the rating label and within these instructions you will find among others the following symbols and abbreviations. Familiarise yourself with them to reduce hazards like personal injuries and damage to property. V~ volt, (alternating voltage) a amperes hz hertz w watt /min o...
Page 16
Customer service 1300 653 177.