Wallpro PS-1000 Operating Instructions Manual - Customer Service

Manual is about: POWER SANDER

Summary of PS-1000

  • Page 1

    Operating instructions power sander model ps-1000

  • Page 2

    Model no ps-1000 voltage 230v /50hz no load speed 650 ~1600/min full load speed 280 ~ 950/min power input 550w sanding disc diameter 225mm net weight 4.7 kg (10 lbs.) view of the major components & accessories specifications sanding head column hand grip on/off switch vacuum swivel mount speed adjus...

  • Page 3

    Warning! Read and understand all instructions. Failure to follow all instructions listed below, may result in electric shock, fire and / or serious personal injury. The term ‘power tool’ in all of the warnings listed below refers to your mains-operated (corded) power tool. Save these instructions. 1...

  • Page 4

    5. Do not overreach. Keep a proper footing and balance at all times. Proper footing and balance enables better control of the tool in unexpected situations. 6. Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and gloves away from moving parts. Loose clothes, jewelry or...

  • Page 5

    1. Keep hands away from rotating sanding head area at all times! 2. Prolonged breathing of airborne dust from plasterboard sanding may effect respiratory function or cause serious respiratory illness. To reduce exposure to dust always wear approved protective equipment*, ensure power sander is conne...

  • Page 6

    Total extension cord length (feet) cord size (awg) 25 16 50 12 100 10 150 8 200 6 unpacking carefully remove the tool and all loose items from the shipping container. Retain all packing materials until after you have inspected and satisfactorily operated the machine. Carton contents 1. Power sander ...

  • Page 7

    To install the vacuum cleaner hose: 1. Unplug the machine. 2. Plug the vacuum cleaner hose bayonet mount into the swivel mount in the back of the machine. Once the tangs of the bayonet mount are fully inserted in the slots, hold the swivel mount from turning and turn the hose bayonet mount clockwise...

  • Page 8

    1. Place the two d-handle brackets in place on the column forward of the grip. 2. Thread in the 4 socket cap screws and tighten with the hex wrench located in the d-handle. 3. The d-handle may then be placed in any of 3 angles. Position in the desired angle then thread in the 4 socket cap screws. 4....

  • Page 9

    When new, the carbon brushes will last approximately 50 hours of running time or 10,000 on/off cycles. Replace both carbon brushes when either has less than 6mm length of carbon remaining. To inspect or replace brushes, first unplug the machine. Carefully remove the 6 screws on the right side and 1 ...

  • Page 10

    Ps-1000 exploded view.

  • Page 11

    Ps-1000 parts list no. Parts name qty 1 power supply cable 1 2 cord armor 1 3 vacuum extension hose 4m 1 4 quick release hose connector 1 5 screw m4 x 16 7 6 right handle cover 1 7 left handle cover 1 8 cable clip 1 9 screw m4 x 14 2 10 screw m4 x 25 2 11 speed control 1 12 wire connector 1 13 wire ...

  • Page 12

    Warranty wallboard tool co pty ltd warrants that this product will be free from any defect in materials or workmanship for twelve (12) months from your purchase date (noted on your invoice or receipt). At its discretion, wallboard tool co pty ltd will either repair or replace your product, if it is ...

  • Page 14

    Customer service 1300 653 177.