Wallpro PS-1000 Operating Instructions Manual - page 8
1. Place the two D-Handle Brackets in place on the column forward of
the grip.
2. Thread in the 4 socket cap screws and tighten with the hex wrench
located in the D-Handle.
3. The D-Handle may then be placed in any of 3 angles. Position in the
desired angle then thread in the 4 socket cap screws.
4. Tighten with the hex wrench and when done, store the wrench in its
slot in the D-Handle.
1. Once the machine and vacuum cleaner are set up and all safety measures and equipment are in
place, begin by turning on the vacuum cleaner and then the machine. (If you are using a vacuum
cleaner with integrated switching, then simply turn the machine on.)
2. Begin sanding and carefully contact the work surface as lightly as possible-just enough to keep the
sanding head flat against the surface.
3. The joints in the sanding head allow the sanding disc to follow the contours of the work surface.
4. The best technique is to use overlapping sweeps and keep the head in constant motion. Never
stop too long in any one place or there will be swirl marks. With experience it will be very easy to
create excellent results.
NOTE: Ensure that the sandpaper you are using is suited to the task. Overly coarse grit
paper may remove material too quickly to control. While overly fine grit paper may clog
too often and not shape down the surface.
CAUTION: Take care to avoid pointed projections and nails, etc. This will wipe out the
sandpaper and probably damage the sponge pad as well.
Keep Tool Clean
Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a
soft damp cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise
damage the material. Wear safety glasses while using compressed air. Clean the vacuum swivel
connector as too much dust will keep it from turning freely.
The carbon brushes
The carbon brushes are a normal wearing part and must be replaced when they reach their wear limit.
NOTE: Checking and replacing the carbon brushes should be entrusted to a qualified
service center.
Mounting the Optional D-Handle
Sanding Operations
Maintenance