Automatic volume control for boat stereos ws 1107 wired controller for mb quart marine stereos installation & operation instructions.
Contents i chapter 1 installation instructions ............................................1 control unit .............................................................2 power cable ............................................................4 stereo control cable .......................................
1 installation instructions 1 read through all instructions before installing. The boost box is designed to install easily on almost any boat with little or no wiring modifications. Simply attach the control unit to the boat with the enclosed velcro tape, connect the power cable to the boat’s 12-vol...
2 chapter 1 installation instructions step 1 – control unit installation the control unit must be mounted with the control knob facing the driver, and the unit must be mounted within 10° of level with respect to the boat’s waterline. The unit can be mounted either horizontal or vertical (see figures...
3 chapter 1 installation instructions note: if the unit is not mounted properly, it will not properly sense the boat’s acceleration. Below are some examples of incorrect mounting of the control unit. Incorrect! Knob is facing up but should be facing the driver. Centerline (front to back) of the cont...
4 chapter 1 installation instructions step 2 – power cable installation the power cable plugs into the back of the control unit, as shown below, and the free end is wired into the boat’s 12-volt power. Connect the red wire to power and the black wire to ground. Connect the power cable to a circuit p...
5 chapter 1 installation instructions step 3 – stereo control cable installation the stereo control cable plugs into the back of the control unit, and into the back of the mb quart stereo head unit. Both ends of the cable are male 3.5mm jacks and the ends of the cable are labeled. The proper ends mu...
2 using the boost box 6 the boost box is designed to adjust the stereo volume when pulling riders. When installed properly, the device sends remote control commands to the boat’s stereo. The boost box automatically increases stereo volume when it senses six seconds of continuous acceleration, and au...
7 chapter 2 using the boost box calibration: the control unit automatically calibrates (resets) its internal sensors every time it is turned on. This precisely calibrates the sensors to the boat’s level position in the water. To calibrate the boost box: 1. Ensure the boat is in flat water with no ro...
3 troubleshooting guide 8 below are some possible conditions and solutions. Condition solution unit will not turn on. Unit turns on, but boat volume does not change when boat pulls a rider and led does not flash. Led flashes when boat pulls a rider, but stereo volume does not increase. Volume is slo...
4 release of liability assumption of risk 9 important – you must read this the boost box is a high performance mechanism designed solely for use with water ski and wakeboard boats operating under ideal, calm conditions utilizing a spotter and all other safety crew and requirements of tournament wate...
Limited warranty during the first 12 months from date of original retail purchase, any boost box component that fails due to defects in materials or workmanship will be repaired or replaced at the option of watersport innovations at no charge. Warranty excludes components damaged by improper install...
