WAV SportLine 480 Owner's Manual

Summary of SportLine 480

  • Page 1

    480 & 520 owner’s manual vol. 1 technical documentation declaration of confomity owner’s manual vol. 2 warnings sportline.

  • Page 2: Sportline

    · please read this manual carefully before using your boat. · this owner's manual includes two volumes that must be kept together. E n g l i s h the owner's manual includes two volumes: - volume 1 deals with user precautions and safety recommendations to be observed. - volume 2 deals with technical ...

  • Page 3

    Sportline series dimensions 480 520 total length: (meters) 4.9 5.2 total width: (meters) 2.1 2.1 inside width (meters) 1.1 1.2 boat weight (kg) 260 350 buoyancy tube diameter (meters) 53 48 capacity hermetically sealed compartments 5 5 persons 10 10 maximum weight (1) (kg) 1100 1100 speedboat data s...

  • Page 4

    E n g l i s h general characteristics 1 2 3 10 4 5 6 14 7 15 8 9 11 16 17 12 13 3 1. Bow roller * 2. Bow step * 3. Double storage seat 4. Navigation lights * 5. Anchor light * 6. Cable outlet 7. Two way back 8. Steering wheel 9. Side console 10. Bilge pump hatch 11. Lifeline 12. Handel 13. Bow cleat...

  • Page 5

    We recommend that you follow the precise order given in the opening procedure. Work step by step and refer to the corresponding document. Procedure section 1. Make an inventory of the parts of the boat and get to know them. Check when opening the package 3. Put the valves in inflating position infla...

  • Page 6: Note:

    Inflation system semi built in valves inflation position deflation position valve closed, the inside spring button moves upwards. Valve opened, the inside button sinks and turns to the left. Note: you must always put the valve cap back after inflation or deflation · install the pipe (element 2) on t...

  • Page 7: Note:

    Inflate at a maximum pressure of 220 mb, (refer to the pressure section) taking care that all compartments are equal. Never inflate a compartment to the final pressure if the other compartments are fully deflated note: · when the buoyancy mechanism is correctly inflated, the internal partitions (1) ...

  • Page 8: Note

    We recommend that you should buy a pressure indicator from your dealer. You can use it to make a fast and efficient check of the pressure during inflation. If you do not have a pressure indicat or, stop inflating when it becomes difficult to operate the foot pump, and when the boat becomes "hard" (y...

  • Page 9

    Standard equipment ! Caution check that the deck plug hole is firmly fixed before launching the boat 1. Motor mounting 2. Caps 3. The hull plug hole cap is screwed into the flange. Turn it into the anti-clockwise direction to unscrew it or in the clockwise direction to screw it. The flange is mounte...

  • Page 10

    Gear lever location 1 gear lever control osition. 2. Glass fibre (grp) - console . Cables outlet 1. Cables outlet for steering cables plus any extra cables 2. Cables outlet for remote control cables , fuel hose and electric cables install remote control in this position 1. Self drain plug from deck ...

  • Page 11: Console

    Seats and storage 1 2 3 4 5 10 1. Driving double locker seat position - 1 2. Driving double locker seat position - 2 3. Driving double locker seat storage 4. Bow seat 5. Bow seat locker 1. Fiberglass console 2. Gauge position 3. Console hatch 4. Electric panel 5. Position for extra devices. Console ...

  • Page 12

    Bow step and roller e n g l i s h 11 2 1 1. Bow step 2. Bow roller the console electric switches 1 bilge pump. 2 navigation lights on up navigation lights off middle anchor light only down 3 this control panel is impermeable and is provided with an additional switch reserved for an optional accessor...

  • Page 13: Rollbar

    Rollbar 1. Stainless steel rollbar 2. Nav lights position 3. Anchor light position 4. Rollbar base 2 1 3 4 12.

  • Page 14

    Boat maintenance towing 13 1. Wash the boat with clean water, taking special care to remove sand or small stones that could have slid between the buoyancy mechanism and the grp hull. 2. Drain all water, all sand and all stones from the boat, by opening the plug hole cap and allow to dry. 3. Store th...

  • Page 15

    14 putting on trailer e n g l i s h please adjust your trailer carefully in order to let your boat rest in a correct position as shown in picture.

  • Page 16

    Iv -3-connecting the options iv -3-1-precautions: nevertheless, 4 spare positions remain in the fuse box (below the console) to connect additional accessories in some conditions: x the accessories to add must be connected on the console. X the accessories are divided into two categories: a-- accesso...

  • Page 17

    Example 1 to add: a 72-w vhf, a 36-w gps, a 72-w cigarette lighter, a 20-w clock. Example 2 to add: a 60-w vhf, a 36-w gps, a 48-w radio, a 120-w projector.. 16 a hold fan radio depth-finder gps 36 w projector alarm system fridge vhf 72 w Ȉ 108w ( b miscellaneous lights miscellaneous electronic equi...

  • Page 18

    Example 3 to add: a 60-w gps, a 60-w radio, a 120-w buzzer. Note: some manufacturers indicate the intensity instead of the power consumed. For dc (as is the case), just multiply by 12 (the battery is 12 v) to obtain the power. Iv -3-2-wiring: x choose a free fuse position, x connect the accessory po...

  • Page 19

    1 / 1 warning.

  • Page 20: Workscertificate

    Eal/011-09/98 aussteller: eal verteiler: vertrieb, kunde workscertificate workscertificate (en 10204 2.1) these indicated technical data are based to the form „artikelspezifikation – technisches datenblatt“ article valmex inflatable boat material article - no.: 7311 / 7318 / 7307 / 7321 resistance t...

  • Page 21

    Quality system the ultraflex and uflex quality systems are certified cisq-iqnet by the italian shipping registry (rina), in conformity with the uni en iso 9001:2000 rule. Ultraflex certification n°6669/02/s (former 420/96). Uflex certification n°8875/03/s . The quality system involves all the compan...