Av6201a opengear analog video distribution amplifier w/ differential input, clamping and cable equalization user manual by wardbeck systems rev:jan.01 2015.
Wardbeck part number: av6201a • document issue: 1 • printed in canada the information contained in this user manual is subject to change without notice or obligation. Copyright © 2015 wardbeck systems ltd. All rights reserved. Contents of this publication may not be reproduced in any form without...
Important regulatory and safety notices before using this product and any associated equipment, refer to the “important safety instructions” listed below so as to avoid personnel injury and to prevent product damage. Products may require specific equipment, and /or installation procedures be carried...
Emc notices us fcc part 15 this equipment has been tested and found to comply with the limits for a class a digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial env...
Environmental information the equipment that you purchased required the extraction and use of natural resources for its production. It may contain hazardous substances that could impact health and the environment. To avoid the potential release of those substances into the environment and to diminis...
Introduction overview the av6201a is an analog video distribution amplifier with a differential input designed for broadcast use. It can provide up to eight outputs when used with a single card rear module, and up to four outputs when used with a double card rear module in an og3frc frame. The av6...
Installation and setup static discharge whenever handling the av6201a and other related equipment, please observe all static discharge precautions as described in the following note: esd susceptibility static discharge can cause serious damage to sensitive semiconductor devices. Avoid handling circu...
Board installation use the following procedure to install the av6201a in an opengear og3frc series frame. 1. Refer to the user manual of the opengear og3frc series frame to ensure that the frame is properly installed according to instructions. 2. When using the av6201a with the t6301a for maximu...
User controls user control diagram figure 3. Cardedge user controls level the level control is used to adjust the output levels of the av6201a. This potentiometer gives precise control of the output signal over a +/3 db range. Equalizer (0300m) provides continuously variable equalization for cabl...
Jumper settings selects the input termination, either high impedance or 75 ohms. Selects between a balanced and differential input configuration. Turns clamping circuit on or off. Remote control dashboard control this card may be monitored by a remote computer through dashboard the free configuratio...
Technical specifications input input impedance 75 ohm or hiz input level 1 vpp, nominal input return loss 46db typical, @ 3.58m performance gain better than 0.05 db @ 3.58m differential gain better than 0.15% @ 3.58m differential phase better than 0.15 deg @ 3.58m s/n better than 60db, 5mhz b.W. O...
Warranty and repair policy the opengear av6201a is warranted to be free of any defect with respect to performance, quality, reliability, and workmanship for a period of five (5) years from the date of shipment from our factory. In the event that your opengear av6201a proves to be defective in any wa...
Ordering information standard equipment ● av6201a analog video distribution amplifier w/differential input, clamping and cable equalization distribution amplifier optional equipment ● av6201aum analog video distribution amplifier user manual (additional user manual) ● t6301a single card rear module ...