X10 AM466 User Manual

Ratings

The Appliance Module can be used to control

an incandescent lamp rated up to 500W.

X10 Wireless Technology, Inc. Limited One Year Warranty

X10.com, a division of X10 Wireless Technology, Inc. (X10) warrants X10

products to be free from defective material and workmanship for a period of

one (1) year from the original date of purchase at retail. X10 agrees to repair

or replace, at its sole discretion, a defective X10 product if returned to X10

within the warranty period and with proof of purchase. If service is required

under this warranty:

Call 1-800-442-5065, visit www.x10.com, or e-mail support@x10.com.

For help or more information on setup, please visit:

http://www.x10.com/support

AM486/AM466-11/02

Check Out our Web site at:

http://www.x10.com

For more information on X10 products and

special promotional offers.

Setting The Module’s Code

Using a small screwdriver, set the red

House Code dial to the same letter as your

Controllers. Set the Black Unit Code dial to

any unused number.

UNIT CODE

DIAL

HOUSE CODE

DIAL

3.

Plug the Module into

the same wall outlet as

your controller (see

testing below).

2.

Plug an appliance

into the Module.

1.

Set the House Code

and Unit Code.

It can also control other types of lamps such as fluorescent or energy saving

lamps, low voltage lamps, or lamps that include a dimmer control. And of course

it can be used to control appliances. Caution: Observe the ratings on the label

on the back of the Appliance Module.

Testing The Module

Make sure the appliance’s switch is on. Plug the Module into the same wall

outlet as your controller, press the On and Off buttons on the controller that

correspond to the Unit Code setting on the Module. If the Module turns on and

off you can unplug the Module or Controller and move it to its permanent

location. If you can’t control the module, visit http://www.x10.com/support

for help.

Appliance Modules AM486 (2 pin) and AM466 (3 pin)