X10 IN62A Setup Instructions

GUIDE:

IN62A

Copyright 2001 X10 Wireless Technology, Inc. All rights reserved.

Connect the power supply to the VCR

Commander and plug it into a wall outlet.

Have someone walk in front of your FloodCam

within 30 seconds of your pressing PLAY.

The LED on the VCR Commander will go

out.

Press and hold PLAY until the LED stays on.

Press and hold REC until the LED stays on.

Place your remote control 1 inch away from

the VCR Commander.

Press REC on the VCR Commander and

release it. The LED will blink quickly and then

stay on. Press the Record button on your

remote and keep pressing it until the LED on

the VCR Commander briefly goes out and

comes back on solid. This means that Record

has been learned.

Repeat these steps again for the STOP

function.

Plug the IR emitter cable into the back of the

VCR Commander.

Press the emitter onto the VCR you are going

to control, after removing the plastic from the

adhesive backing.

Get more help at: http://www.x10.com/support

VCR Commander & FloodCam

(Install your FloodCam before getting started.)