X10 LM14A Installation And Operating Instructions

Check Out our Web site at:

www.x10.com

For more information on X10 products and

special promotional offers.

X10 Wireless Technology, Inc. Limited One Year Warranty

X10.com, a division of X10 Wireless Technology, Inc. (X10) warrants X10

products to be free from defective material and workmanship for a period of one

(1) year from the original date of purchase at retail. X10 agrees to repair or replace,

at its sole discretion, a defective X10 product if returned to X10 within the warranty

period and with proof of purchase. If service is required under this warranty:

Call 1-800-442-5065, visit www.x10.com, or e-mail support@x10.com.

For help or more information on setup, please visit:

http://www.x10.com/support

2-Way Lamp Module LM14A

INSTALLATION AND OPERATING INSTRUCTIONS

1. Set the black Unit Code dial on the front of the Module to the desired

number between 1 and 16.

2. Set the red Housecode dial to the same letter as your X10 Controllers or the

same letter as used with your CM11A 2-Way Computer Interface and

ActiveHome software.

3. Make sure the lamp (incandescent only) you want to control is turned on,

and unplug it from its outlet.

4. Plug the lamp into the module.

5. Plug the module into the AC outlet.

To turn the module on/off, press the number corresponding to its Unit Code

on any X10 controller, then press on/off. You will notice that the module has

“Soft Start,” meaning that it gradually dims up from Min. to Max. brightness

when you turn it on.

Note: the LM14A is a 2-Way module so you can poll it (ask it for its status) from

the CM11A 2-Way Computer Interface and ActiveHome software. ActiveHome

will ask the LM14A for its status and the module will report back to indicate

whether it is on or off. The ActiveHome software will then update the graphics

on your computer monitor screen to show the status of the module. See your

owner’s manual for the ActiveHome system for more information.

LM14A-12/02